MITSUBISHI A985GOT-TBD User's Manual A985GOT-TBD SW4D5C-GOTR-PACKE compatible Connection System Manual Manual

32 point connector for compressed flat cable (37 pin D-Sub connector).34 point with the wiring transformation adapter 2 line type 16 point input CC-Link unit installation special connection conversion adapterInput type: DC input, positive common end.
Input points: 16 points.
Enter the response time: 1 A985GOT-TBD User's Manual. 5ms the following.
Rated input voltage / current: DC24V/5mA.
External connection: 3 wire A985GOT-TBD
Spring clip terminal.
Do not need to be tightened further or locked with screws, which can reduce the working hours of wiring.
Using 2 pieces of structure of the terminal units, maintenance can be maintained in the same line under the condition of the replacement module.
When installing the module can choose to use the DIN guide rail or screw mounting A985GOT-TBD User's Manual.
Can be used for the 3 wire sensor input wiring. Enter 64 points.
Above DC7V.
Response time: 16ms.
16 pin connector.
Output 64 points.
Response time: 16ms.
32 pin connector dynamic input and output data.
PLC is introduced by the relay control technology after the development of micro processing technology,
Can be easily and reliably used for switching control A985GOT-TBD User's Manual.
As the analog quantity can be converted into digital quantity, the number of digital quantity is just a number of switching value,
Therefore, after the conversion of analog, PLC can also be reliable for processing control.
Because the continuous production process often has the analog quantity, the analog quantity control is sometimes called process control.
Analog quantity is not electricity, and PLC can only handle digital quantity, quantity of electricity.
All to realize the conversion between them to have the sensor, the analog quantity into a number of power.
If this power is not standard, but also through the transmitter,
The non-standard power into a standard electrical signal, such as 1-5V, 4-20mA, 0-10V, etc..
At the same time, there is also an analog input unit (A/D),
Transform these standard electricall signals into digital signals,
The analog output unit (D/A), in order to transform the digital quantity after PLC processing into analog quantity -- standard electric signal A985GOT-TBD Manual.
So the standard telecommunication number, the conversiion between the number of operations to use a variety of computing A985GOT-TBD Manual.
This requires the resolution of the analog unit and the standard electrical signal.