Output type: transistor output, drain type.
Output points: 8 points.
OFF leakage current: 0.1mA.
Output protection function.
Rated load voltage / current: DC12V/DC24V/0.1A.
External connection: 2 wire.
Spring clip terminal.
Do not need to re tighten, suitable for wire specifications for 0.3~1.5MM square C64 Series Manual.
Terminal block is 2 piece structure.
An input module shared by the common terminal of the positive and negative
C64 Series
The 8 point of the output module is appended to the source type.
Can be installed along the 6 direction. No introductionInput type: DC input, positive common end.
Input points: 1 points.
Enter the response time: 1.5ms the following.
Rated input voltage / current: DC24V/4mA.
Output form: transistor output, leakage type C64 Series Manual.
Output points: 1 points.
OFF leakage current: 0.1mA.
Output protection function: No.
Rated load voltage / current: DC24V/0.1A.
External connection: 3 line /2 line type.
Cable type.
Minimum size of industry.
Can be like a cable, placed in the online slot.
The communication cable and the external equipment connecting cable is a type, and the wiring is simple C64 Series Manual.
Communication side, input and output side with cable (50cm). Input type: DC input, positive public end / negative public end.
Input points: 8 points.
Enter the response time: 0.5ms/1.5ms the following.
Rated input voltage / current: DC24V/4mA MITSUBISHI CNC Manual.
External connection: 2 wire.
Screw terminal table type.
Minimum size of industry.
The connection object at a glance with terminal cover plate MITSUBISHI CNC Manual.
Input module for public end of positive pole and negative pole.
Terminal table structure capable of connecting with 2 wire type sensor and load in the same condition.
Can be installed along the 6 direction.
No introductionOutput type: transistor output, source.
Output points: 16 points.
OFF leakage current: 0 MITSUBISHI CNC Manual. 1mA.
Output protection function.
Rated load voltage / current: DC12V/DC24V/0.1A.
Externnal connection: 1 wire C64 Series SPECIFICATIONS MANUAL.
MIL connector type.
Minimum size of industry.
Relay terminal, terminal station conversion module and electromagnetic valve, etc. are connected to a simple MIL connector.
Simply remove the connector can be reeplaced with a simple module C64 Series Manual.
Additional module power supply, I/O power sharing.
No additional I/O power supply, you can reduce the cost and set space.