MITSUBISHI FX3GE-40MT/DS Basic & Applied Instructions Edition PROGRAMMING MANUAL

MITSUBISHI inverter FR-F720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 30KW.
When the ring is opened, the frequency converter is provided with a load of the motor when the motor is operated with a load at a given frequency,
The range of the motor speed in the rated slip ratio (1%~5%) changes FX3GE-40MT/DS Basic & Applied Instructions Edition.
For the requirements of relatively high precision, even if the load changes are also required to operate at a given speed of the occasion,
Inverter with PG feedback function can be used (selection) FX3GE-40MT/DS
If the given acceleration time is too short, the output frequency of the inverter is far more than the change of the speed (electric angular frequency),
Converter will be due to flow over the current trip, the operation stopped, which is called stall FX3GE-40MT/DS Basic & Applied Instructions Edition. MITSUBISHI inverter series: FR-A820.
Voltage level: three phase 200V.
Power: 11kw.
SLD converter rated current: 63A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Parameters can be selected by 4 different rated current and different overload rating (SLD (ultra light load) rated, LD (light load) rating, ND (general load) rating, HD (weight) FX3GE-40MT/DS Basic & Applied Instructions Edition.
Type load) for selection.
You can choose the most suitable frequency converter for use; and by selecting a transducer with a SLD or LD rated level,
Be able to reduce the size of the device (compared with the FR-A700 series, to reduce the volume of equipment).
For applications that require high torque at low speeds, the HD rating is the most suitable.
The controller is used to control and monitor the frequency converter through the network.
Standard corresponding RS-485 communication (MITSUBISHI converter protocol, Modbus-RTU protocol) data transmission speed up to 115200bps. Length: 5.0m.
Specification: TB-FX round cable. RS-232C communication adapter.
(need FX1N-CNV-BD).
(FX1S and FX1N host general). The connector is converted to a spring clip terminal row.Convert connectors to e-CON.Input points: 24 points.
Output points: 16 points.
Power supply voltage: AC160-240V.
Output type: transistor output (source).
Built in CPU, power supply, input and output. While maintaaining the convenience of FX1N while improving performance FX3GE-40MT/DS PROGRAMMING MANUAL.
Special adaptor and function expansion board can be installed and used FX3 series.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Applicatioon instruction: 0 FX3GE-40MT/DS PROGRAMMING MANUAL. 5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function.