E5EC-RR4ASM-009 User's Manual OMRON E5EC-RR4ASM-009 RS-485 CompoWay/F Manual

Size: M30, Non-shielded.
Sensing distance: 20.0 mm.
Connection: M12 connector.
Body material: Brass.
Thread length (overall length): 44 (58)(See note.).
Output configuration: PNP.
Operation mode NC.
Safe Mounting with Greater.
Sensing Distance.
Ensures a sensing distance approximately 1.5 to 2,
times larger than that of any conventional OMRON Sensor OMRON E5EC-RR4ASM-009 Manual.
Problems such as the collision of workpieces are eliminated E5EC-RR4ASM-009
Full range of standard sizes (M8, M12, M18 and,
M30; both long and short barrels).
Modular construction simplifies customization. Sensing method: Through-beam type (with slot).
Sensing distance (slot width): 13 mm (slot width).
Output type: NPN output.
Outpu configuration: Dark-ON OMRON E5EC-RR4ASM-009 Manual.
A Wide Slot Width of 13 mm and.
Superior Resistance to Light.
Interference and Noise.
Noise resistance equivalent to photomicrosensors with built-in amplifiers.
Resistance to common noise at least 30 times that of previous models.
Resistance to inverter noise at least 10 times that of previous models.
Reverse polarity protection built in. Size: 48 x 96mm.
Category: power AC100 ~ 240V with OMRON E5EC-RR4ASM-009 Manual.
Shell color: black.
Control output 1: position ratio with relay output.
Control output 2: position ratio with relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 2.
Transfer output: transfer output (special terminal).
Remote SP:4 to 20mA input.
Communication: -.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (Ver.4.3 CX-Thermo) makes the pprocess of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output E5EC-RR4ASM-009 User's Manual.
Through the infrared port can be carried out from the frront of the communication E5EC-RR4ASM-009 User's Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.