SGMPH-08ABE2D YASKAWA SGMPH-08ABE2D

Servo motor type SGMPH (speed: 3000r\/min).
Power: 1.5kw.
Power supply voltage: three phase AC200V.
Serial encoder: 13 bit relative value.
Design sequence: Waterproof standard IP67.
Shaft end: straight shaft without key.
Optional parts: no brake oil seal.
Partial flat series: the need to install the servo motor in a small space YASKAWA SGMPH-08ABE2D.
Flexible user system.
For you to build the best system to enrich the product line to support you SGMPH-08ABE2D
Products with single phase 200V, single phase 100V, three-phase 200V,
And for the absolute value encoder, a variety of motor with brake, belt speed reducer.
And then, because of its compliance with international standards, in the world can be assured that the use of.
Smooth running, there is a very seasonal rate of observation and control,
The speed fluctuation of the motor is greatly reduced, and the speed of the motor can be smoothly operatedType: SGDH type drive YASKAWA SGMPH-08ABE2D.
Capacity: 0.75kw.
Voltage: three phase 200V.
Mode: torque, speed, position.
Test platform for mutual feedback of servo driver and motor.
Test platform with adjustable analog load.
A test platform with an actuator that has no load is used YASKAWA SGMPH-08ABE2D.
Test platform for driving the inherent load by using motor.
Test platform using on line test method.
This test system is composed of three parts,
Were measured servo driver - motor system, the system inherent load and host computer YASKAWA Waterproof motor.
The host computer sends the speed command signal to the servo driver, and the servo system starts to run according to the instruction YASKAWA Waterproof motor.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data. High performance, use the best type of servo unit (purpose type) YASKAWA Waterproof motor.
Maximum applicable motor capacity: 0.2kw.
Power supply voltage: single phase AC100V.
Interface: MECHATROLINK-III communication command type (linear servo motor).
Design sequence: B.
Hardware specifications: paint.
Interface: fixed point through output function.
Use the best type of sigma -V-FT series
According to different uses, there are 5 equipped with a convenient function of the servo unit models.
FT001 (vibration suppression function to upgrade specifications): by strengthening the vibration suppression function, shorten the positioning time.
FT003 (pressure feedback function): high precision pressure control, to promote the high performance of the device.
FT005 (support for rotary table purposes): with the rotation oof the coordinate function and fixed point through the output function, can be smooth and high-precision control of rotary table SGMPH-08ABE2D.
FT006 (fixed point through the output function): no need to pass through the upper device can bee set through the output (Chu Fa) YASKAWA SGMPH-08ABE2D.
FT008 (absolute value system support): the absolute value of the system can be constructed by any upper controller.