D4F-102-1D Manual OMRON safety door switch D4F-102-1D INSTRUCTION sheet

Release key type: Trapped key *1.
Indicator: Green.
Lock and release types: Mechanical lock Solenoid release.
Contact configuration(door open/closed detection switch,
and lock monitor switch contacts): 2NC/1NO+2NC/1NO.
Conduit opening: M20.
Holding Force of 3,000 N.
Two safety circuits and two monitor contacts provide an,
array of monitoring patterns OMRON safety door switch INSTRUCTION sheet D4F-102-1D
Standard gold-clad contacts enable use with ordinary loads,
and microloads.
Models with trapped keys prevent workers from being locked,
in hazardous work areas.
Models with rear release buttons allow people to unlock the,
Switch and escape if they are locked into hazardous areas.
IP67 degree of protection. Specifications: Inputs;
NPN (+ common); 32 points OMRON safety door switch INSTRUCTION sheet.
I/O connections: MIL connector.
Rated internal circuit power supply voltage:
Supplied from the communications connector.
Rated I/O power supply voltage: 24 VDC.
Very Compact 16-/32-point Remote Terminals.
Used in combination with Interface,
Conversion Boards (e.g., D-Sub) to,
connect to a wide range of interfaces.
35 x 60 x 80 mm (W x D x H). Ratings: 1 A at 125 VAC OMRON safety door switch INSTRUCTION sheet.
LED indicator: With indicator.
Actuator: Center roller lever.
Many Models Including Roller Lever.
Switches are Only 16-mm Thick with Connector.
New center roller lever models that enable ganged mounting D4F-102-1D INSTRUCTION sheet.
of up to 6 Switches.
Cable connectors for easy Switch replacement.
Triple-seal construction to provide IEC IP67 degree of protection D4F-102-1D INSTRUCTION sheet.
Operation indicators available for easy monitoring,
(standard indicator is lit when Switch is not operating).
Approved by UL and CSA.
(Ask your OMRON representative for Information on approved models.)
Ratings: 1 A at 30 VDC.
LED indicator: Without indicator.
Actuator: Pin plunger D4F-102-1D INSTRUCTION sheet.
Many Models Including Roller Lever.
Switches are Only 16-mm Thick with Connector.
New center roller lever models that enable gangeed mounting D4F-102-1D Manual.
of up to 6 Switches.
Cable connectors for easy Switch replacement.
Triple-seal construction to provide IEC IP67 degree of protection.
Operation indicators available for easy monitoring,
((standard indicator is lit when Switch is not operating) OMRON safety door switch INSTRUCTION sheet.
Approved by UL and CSA.
(Ask your OMRON representative for Information on approved models.)