E2EQ-X15X1-M1GJ-1 Manual OMRON proximity switch E2EQ-X15X1-M1GJ-1 INSTRUCTION sheet

Appearance: Shielded, M12.
Sensing distance: 3 mm.
Output configuration: DC 2-wire (1)-(4) pin arrangement.
Operation mode: NO.
Spatter-resistant Fluororesin,
coated Proximity Sensor.
Superior spatter resistance.
Long Sensing-distance Models added for sensing,
distances up to 15 mm.
Pre-wired Smartclick Connector Models are also available OMRON proximity switch INSTRUCTION sheet. Size: 48 x 96mm E2EQ-X15X1-M1GJ-1
Ontology: terminal type, temperature input type.
Category: control output 1 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output: voltage output (SSR driver).
Control mode: standard or heating cooling.
Auxiliary output points: 3 points.
The heater is used to break, SSR fault, heater over current detection function /ES1B power supply: single phase or three phase heater with detection function OMRON proximity switch INSTRUCTION sheet.
Event entry point: 2.
Transfer output: -.
Communication: -.
The general temperature controller 96mm, 48 * 96mm square has been upgraded to improve the performance and function of /.
Indicates that the accuracy of the upgrade, increase the function of prevention and maintenance, further enhance the performance OMRON proximity switch INSTRUCTION sheet.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/STOP, alarm), interactive display PV/SV.
Increase the number of control output ON/OFF counting function, can prevent the maintenance of temperature controller internal relay E2EQ-X15X1-M1GJ-1 INSTRUCTION sheet.
Increased the 3 segment display, which can display the current value / target / operation E2EQ-X15X1-M1GJ-1 INSTRUCTION sheet.
Increased the PF key, the distribution of automatic / manual, RUN/STOP, etc., can be a key operation. E32-D21R type: standard type; soft (new standard),
Specialty: M3 screws (small),
Bending radius (mm): R; R1.
Standard test object (minimum test object) (mm) 1: (0.005),
Fiber element for meeting diversified needsSensing method: Through-beam type E2EQ-X15X1-M1GJ-1 INSTRUCTION sheet.
Sensing distance(slot width): 3.6 mm.
Output type: NPN output.
Output configuration: Light-ON.
Cable length: 1 m.
Photomicrosensor with built-in,
amplifier and attached cable reduces,
external light interference.
Light modulation effectively reduces external light interference.
Wide operation voltage raange: 5 to 24 VDC E2EQ-X15X1-M1GJ-1 Manual.
Easy operation monitoring with bright light indicator. E32-T22L type: special beam type; long range / high function,
Features: with 2 cylinder (small),
Shape / detection distance (mm): 5400; 440; 250 (100),
Bending radius (mm): R10 OMRON proximity switch INSTRUCTION sheet.
Standard test object (minimum test object) (mm) 1: 0.9 (0.005),
Fiber element for meeting diversified needs