E3X-DAG41-S Manual OMRON photoelectric sensors E3X-DAG41-S INSTRUCTION sheet

E3JM-10S4T detection methods: the firing pattern,
Connection: terminal plate,
Detection range: 10m.
Output status: ON into the light; light shading ON; switch conversion type.
Function: timer,
Output: DC no contact.
2 types of cost reductionSize: 48 x 96mm.
Ontology: terminal type, temperature input type OMRON photoelectric sensors INSTRUCTION sheet.
Category: control output 2 point type (power supply AC100 ~ 240V) E3X-DAG41-S
Shell color: black.
Control output 1: relay output.
Control output 2: high life relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 3 points.
A power supply for the detection of /ES1B fault, SSR fault and heater over current for heater use.
Event entry point: 2.
Transfer output: -.
Communication: - OMRON photoelectric sensors INSTRUCTION sheet.
The general temperature controller 96mm, 48 * 96mm square has been upgraded to improve the performance and function of /.
Indicates that the accuracy of the upgrade, increase the function of prevention and maintenance, further enhance the performance.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/STOP, alarm), interactive display PV/SV.
Increase the number of control output ON/OFF counting function, can prevent the maintenance of temperature controller internal relay OMRON photoelectric sensors INSTRUCTION sheet.
Increased the 3 segment display, which can display the current value / target / operation E3X-DAG41-S INSTRUCTION sheet.
Increased the PF key, the distribution of automatic / manual, RUN/STOP, etc., can be a key operation. Size: 48 x 48mm E3X-DAG41-S INSTRUCTION sheet.
Control output 1: relay output.
Control output 2:--.
Auxiliary output: 2 independent points.
Power supply voltage: AC100 ~ 240V.
Terminal type: screw terminal table type.
Input category: full range multi input.
Heater break, SSR fault detection function: -.
Communication: -.
Event input: 4 points E3X-DAG41-S INSTRUCTION sheet.
Remote SP input: -.
Transfer output: -.
Using large font PV display (white), improve visibility.
Selection, operation and setting.
Functional performance of input and output points.
Support for more extensive range of applications.
Using high PV 15.2mm display (white), improve visibility.
High speed sampling to achieve 50ms.
With auxiliary output (maximum 3 points), event input (maximum 4 points), the transmission output,
Remote SP input function, support for a variety of applications.
E5CC 600mm has a depth of slender body E3X-DAG41-S Manual.
The use of communication adapter cable (sold separately) connected with a computer.
After that, no power supply connection can be set.
It can be easily set by CX-Thermmo (sold separately) OMRON photoelectric sensors INSTRUCTION sheet.
Easy to connect with PLC through no program communication.
Combined temperature control device through component communication.