FR-A840-06100-2-60 Manual MITSUBISHI INVERTER FR-A840-06100-2-60 DETAILED Instruction manual

Length: 0.3m.
Specification: FX round connector, FX square connector. Needle number: 20.
Specification: loose wire connector, 5 sets (0.3mm 2). MITSUBISHI inverter series: FR-A800.
Voltage level: three phase 400V.
Power: 450kw.
SLD converter rated current: 1094A.
Structure and function: the rectification part is off type MITSUBISHI INVERTER Instruction manual.
Type: CA.
Substrate coating: have.
To maximize the performance of the motor FR-A840-06100-2-60
Advanced auto tuning function.
The newly developed PM motor auto tuning feature can be used to operate other manufacturers of PM motors (Yong Ci synchronous motors) in the sensorless state.
Not only can drive MITSUBISHI induction motor and PM motor, but also can drive other manufacturers of induction motor and PM motor MITSUBISHI INVERTER Instruction manual.
This means that you can reduce the cost of inventory and supplies.
If the PM motor is produced by a IPM motor or other company using MM-CF, the starting torque is limited to 50%,
Even after tuning is not simple to use and positioning control of zero speed torque) induction motor and permanent magnet motor can be combined freely. MITSUBISHI inverter FR-A740 series.
Voltage level: 3 phase 400V MITSUBISHI INVERTER Instruction manual.
Frequency converter capacity: 15KW.
FR-A700 converter products are suitable for all kinds of high load requirements of the equipment.
Such as lifting, lift, printing and dyeing, printing and dyeing, material coiling and other general occasions FR-A840-06100-2-60 Instruction manual.
High level driving performance.
Unique sensorless vector control mode,
A wide variety of mechanical equipment can be operated at high precision in the super low speed region without the need of the encoder FR-A840-06100-2-60 Instruction manual.
With torque control mode,
And in the speed control mode can use the torque limit function.
With vector control function (with encoder),
Frequency converter can achieve position control and fast response, high precision speed control (zero speed control, servo lock, etc FR-A840-06100-2-60 Instruction manual. ) and torque control. The operation, monitoring, parameter modification and other operations can be carried out by computer or PLC.Max input / output points: 48 points.
Supply voltage: 100 - 240VAC.
Input points: 24 points.
Output points: 24 points.
Output type: transistor.
Power consumption: 50VA.
Weight (kg):0.85.
Size (WxHxD) mm:182x90x87.
Note recording function, Component annotation can be recorded in the program register.
Online program editor, online change the program will not lose the working hours or stop production operation.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software can monitor, upload or uninstall programs and data via modem communications
Password protection, using a eight digitt password to protect your program FR-A840-06100-2-60 Manual .
Clock function and hour meter function, all of the PLC FX2N has a real-time clock standard.
Continuous scanning function, to define the operation cycle for the application off the continuous scan time MITSUBISHI INVERTER Instruction manual.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017).