FX1N-60MR-DS Manual MITSUBISHI PLC FX1N-60MR-DS PROGRAMMING MANUAL II

Memory format: EEPROM.
Number of steps: up to 16000 steps can be used.
Battery support: do not.
Method for writing and deleting: the device is installed on the PLC, and is written and deleted by the peripheral device. Can be isolated from the output of the programmable controller, the a/b/c contact relay, SSR, Tr output MITSUBISHI PLC PROGRAMMING MANUAL II. Power: 7.5kw.
Purpose: to suppress the power harmonics FX1N-60MR-DS
Improve the power factor, reduce the input side of the high harmonic current.
Make sure that this option is installed in the FR-A820-03800 (75K) and FR-A840-02160 (75K) and above capacity and above capacity.
At the same time the installation options in the use of 75kW and above motor. (the IP55 series has a built-in DC reactor MITSUBISHI PLC PROGRAMMING MANUAL II. )
According to the motor power used to select the DC reactor.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.) "MITSUBISHI inverter FR-E720S series.
Voltage level: single phase 200V.
Frequency converter capacity: 1.5KW.
The use of frequency converter motor is in order to speed, and reduce the starting current.
In order to produce a variable voltage and frequency, the device is the first power of the AC power conversion to DC (DC), the process is called rectification MITSUBISHI PLC PROGRAMMING MANUAL II.
The direct current (DC) is transformed into alternating current (AC) and its scientific term is "inverter" (inverter) FX1N-60MR-DS PROGRAMMING MANUAL II.
General inverter is the DC power supply inverter for a certain fixed frequency and a certain voltage of the inverter FX1N-60MR-DS PROGRAMMING MANUAL II.
For the inverter as the frequency adjustable, adjustable voltage inverter, we called the inverter.
Inverter output waveform is simulated sine wave, mainly used in three-phase asynchronous motor speed control, and also called frequency governor. "Input and output points: 32 points FX1N-60MR-DS PROGRAMMING MANUAL II.
Input points: 16 points.
Output points: 16 points.
Output form: transistor output (source).
Weight: 0.65kg.
Input signal voltage: DC24V.
FX2N series expansion unit
Expansion unit is an input and output expansion device with a built-in power supply.
As with the basic unit, the extension unit can be connected to a variety of input and output and special extension equipment.
Can connect to FX3GA/FX3G, FX3GE and FX3U.
AC power model, the built-in maximum DC24V 250mA/460mA supply power.
Because all models of FX series are built in high speed counter,
So the high speed control can be realized by the simple procedure.
The input of the basic unit is built in the anti jitter filter,
One part as digitall filter,
Sensitivity adjustment unit can reach 1ms FX1N-60MR-DS Manual.
Using high speed counter automatically adjusted to the minimum value.
Through the high cost of the built-in positioning function and the expansion function to increase the number of control axis MITSUBISHI PLC PROGRAMMING MANUAL II.
Extended function expansion board and special adapter,
Data links and communication with external serial devices.