FX1S-20MT-ES/UL Manual MITSUBISHI PLC FX1S-20MT-ES/UL HARDWARE MANUAL

Input points: 32 points
Input mode: DC24V (drain / source).
Connection status: connector.
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion module: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points MITSUBISHI PLC HARDWARE MANUAL FX1S-20MT-ES/UL Max input / output points: 20 points.
Power supply voltage: 24VDC.
Input points: 12 points.
Output points: 8 points.
Output type: relay.
Power consumption (W): 7.
Weight (kg):0.3.
Size (WxHxD) mm:75x90x49.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types MITSUBISHI PLC HARDWARE MANUAL.
This type of PLC is mainly used in all of the digital input, digital output control point of the device.
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain.
The series transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor.
The series PLC can not be brought with the expansion module, but can be installed by the BD board to extend a small amount of I/O MITSUBISHI PLC HARDWARE MANUAL.
The series 1N through the installation of BD series PLC board, can achieve RS232, RS485, RS422 communication.
All equipment is digital input and output point FX1S-20MT-ES/UL HARDWARE MANUAL.
The total I/O points are not more than 30 points, and the input points are less than 16, the output points are less than 14.
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simple manipulator FX1S-20MT-ES/UL HARDWARE MANUAL. Axis of control: 1.
Interpolation: No.
Program memory: built-in 3.8k step EEPROM.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V) FX1S-20MT-ES/UL HARDWARE MANUAL.
Not only can deal with single speed positioning and positioning,
Can also carry on the multi section fast operation and so on complex control.
Can not be connected to the PLC, while running alone.
1 can control 1 axes,
FX1N, FX2N, PLC FX3U up to 8 units can be conneected,
PLC FX2NC up to 4 units can be connected,
FX3UC PLC can connect up to 7 units, and a plurality of shafts can be independently controlled FX1S-20MT-ES/UL Manual.
Can output up to 200kHz of the pulse train.
The connection function of thhe absolute position detection function and the manual pulse generator MITSUBISHI PLC HARDWARE MANUAL.
Can be used in the form of flow chart programming software, visual programming.