FX3G-60MT/DS Manual MITSUBISHI PLC FX3G-60MT/DS Hardware Edition USER'S MANUAL

MITSUBISHI inverter series: FR-A820.
Voltage level: three phase 200V.
Power: 7.5kw.
SLD converter rated current: 49A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Parameters can be selected by 4 different rated current and different overload rating (SLD (ultra light load) rated, LD (light load) rating, ND (general load) rating, HD (weight) MITSUBISHI PLC USER'S MANUAL FX3G-60MT/DS
Type load) for selection.
You can choose the most suitable frequency converter for use; and by selecting a transducer with a SLD or LD rated level,
Be able to reduce the size of the device (compared with the FR-A700 series, to reduce the volume of equipment).
For applications that require high torque at low speeds, the HD rating is the most suitable MITSUBISHI PLC USER'S MANUAL.
The controller is used to control and monitor the frequency converter through the network.
Standard corresponding RS-485 communication (MITSUBISHI converter protocol, Modbus-RTU protocol) data transmission speed up to 115200bps. Max input / output points: 40 points.
Power supply voltage: DC24V.
Input points: 24 points.
Output points: 16 points.
Output type: relay.
Power consumption (W): 32 MITSUBISHI PLC USER'S MANUAL.
Weight (kg):0.65.
Size (WxHxD) mm:130x90x75.
FX1N series is a very powerful micro PLC, can be extended to up to 128 I/O points,
And can increase the special function module or the expansion board.
Communication and data link function options make FX1N in the volume, communication and special function modules and other important applications is very perfect FX3G-60MT/DS USER'S MANUAL FX3G-60MT/DS USER'S MANUAL.
A PLC unit can output 2 100KHz pulses at the same time,
PLC is equipped with 7 special positioning instructions,
Including zero return, absolute position readout, absolute or relative drive, and special pulse output control. Memory format: EPROM.
Number of steps:
Can use up to 16000 steps FX3G-60MT/DS USER'S MANUAL.
Battery support: do not.
Method of writing and deleting: write and use ROM to write, use ultraviolet ray to delete. Power: 37kw.
Purpose: to suppress the power harmonics.
Improve the power factor, reduce the input side of the high harmonic current.
Make sure that this option is installed in the FR-A820-003800 (75K) and FR-A840-02160 (75K) and above capacity and above capacity FX3G-60MT/DS Manual.
At the same time the installation options in the use of 75kW and above motor. (the IP55 series has a built-in DC reactor.)
According to the motorr power used to select the DC reactor MITSUBISHI PLC USER'S MANUAL.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.)