FX3GA-40MT-CM PROGRAMMING MANUAL MITSUBISHI FX3GA-40MT-CM Basic & Applied Instructions Edition Manual

Connecting cable for handheld GOT and PLC.
Cable length: 3 meters.
Application: RS-422 connection. Power: 37kw.
Voltage: 200V.
The surge voltage of the motor can be suppressed when the 400V motor is driven by a frequency converter.
Motor suitable for 5.5 to 37kW. Used to reduce radio noise.Total input and output points: 48 points MITSUBISHI FX3GA-40MT-CM Manual.
Input points: 24 points.
Output points: 24 points FX3GA-40MT-CM
Output type: relay output.
Power supply voltage: AC100-240V.
Input signal voltage: DC24V.
8K capacity of the RAM memory, the maximum can be extended to 16K.
CPU arithmetic processing speed of 0.08 S/ basic instructions.
On the right side of the FX2N series can be connected to the input and output expansion modules and special function modules MITSUBISHI FX3GA-40MT-CM Manual.
The basic unit is built in the 2 axis independent maximum 20kHz positioning function (transistor output type).
Quick disconnect the terminal block, which adopts excellent maintainability to quickly disconnect the terminal blocks, even if the cable is then replaced by the cable.
Clock function and hour meter function, all of the PLC FX2N has a real-time clock standard MITSUBISHI FX3GA-40MT-CM Manual.
Continuous scanning function, to define the operation cycle for the application of the continuous scan time.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017).
Note recording function, Component annotation can be recorded in the program register.
Online program editor, online change the program will not lose the working hours or stop production operation.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software can monitor, upload or uninstall programs and data via modem communications
Password protection, using a eight digit password to protect your program. MITSUBISHI inverter FR-E740 series.
Voltage level: 3 phase 400V.
Frequency converter capacity: 2.2KW.
Allow short-time overload (200% 3S).
The machine itself does not need to purchase another operating panel.
Provide USB interface to connect with the computer, you can use the FRConfigurator software to set the parameters of the inverter or monitor.
Inverter surface with PU interface, FR-E500 operating panel can be directly connected to the E700 series FX3GA-40MT-CM PROGRAMMING MANUAL. The installation dimensions are in full agreement with FR-E500.
Allow side by side installation, saving installation space
Simple maintenance: equipped with comb ttype wiring board, wiring more convenient, the replacement of the same series inverter, no stitches, as long as the original inverter control terminal FX3GA-40MT-CM PROGRAMMING MANUAL.