For users intending to connect the GOT directly to a PLC using the RS-422 cable (GT01-C30R4-25P)

Master station module for CC-Link.
FX2N-16CCL-M is the PLC CC-Link as the FX master module.
Up to 7 remote I/O stations and 8 remote stations can be connected to the main station.
Using the CC-LINK FX2N-32CCL interface, you can install PLC FX as CC-LINK remote device station to connect.
In addition, through the connection of various equipment manufacturers, can be applied to a variety of purposes of the system For users intending to connect the GOT directly to a PLC using the RS-422 cable (GT01-C30R4-25P) For users intending to connect the GOT directly to a PLC using the RS-422 cable (GT01-C30R4-25P)
The most suitable for production lines and other equipment control. Connecting cable for handheld GOT and PLC.
Cable length: 1.5 meters.
Application: RS-232C connection (Q series (except for QnU). Max input / output points: 14 points.
Supply voltage: 100 - 240VAC.
Input points: 8 points For users intending to connect the GOT directly to a PLC using the RS-422 cable (GT01-C30R4-25P).
Output points: 6 points.
Output type: Transistor (source).
Power consumption (W): 19.
Weight (kg):0.3.
Size (WxHxD) mm:60x90x75.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, the output points are less than 14.
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simple manipulator For users intending to connect the GOT directly to a PLC using the RS-422 cable (GT01-C30R4-25P).
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0.
FX1S provides up to 30 I/O points, and can be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment. MITSUBISHI inverter FR-F740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 450KW.
The main circuit of the inverter can be divided into two categories in general: voltage type is the voltage source of the DC converter for AC inverter,
The filtering of the DC circuit is the capacitance; the current mode is the DC conversion of the current source to the AC inverter,
The DC loop filter is the inductor.
Why is the frequency of the inverter voltage proportional to the change?
The electromagnetic torque of any motor is the result of the innteraction between the current and the magnetic flux, the current is not allowed to exceed the rated value, otherwise it will cause the heating of the mmotor For users intending to connect the GOT directly to a PLC using the RS-422 cable (GT01-C30R4-25P) For users intending to connect the GOT directly to a PLC using the RS-422 cable (GT01-C30R4-25P).
Therefore, if the magnetic flux decreases, the electromagnetic torque will decrease, which leads to the reduction of the load carrying capacity.