HMI GT2510F-VTND Manual MITSUBISHI GT2510F-VTND MES Interface Function Manual

Cable length: 0.7m.
For the connection between QnAS/AnSCPU/ motion controller GOT (A Series) and CPU.
Applicable models: GT16, GT15, GT11. Cable length: 1.2m.
For QnA/ACPU/ motion controller CPU (A series, extended basis system) and the connection between GOT.
Applicable models: GT16, GT15, GT11. Cable length: 30m GT2510F-VTND Manual .
For connection between QnA/A/FXCPU (D-SUB25 pin connector) and GOT GT2510F-VTND
Connection between serial communication unit (AJ71QC24-R4) and GOT.
Applicable models: GT10, GT21. Cable length: 1.2m.
For QnA/ACPU/ motion controller CPU (A series, extended basis system) and the connection between A7GT-CNB.
Applicable models: GT16, GT15, GT11. A series of high performance models that are widely used in network or single machine work environments GT2510F-VTND Manual .
Screen size: 12.1 inches.
Display color: 256 color or more color.
Installation type: compatible with video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment GT2510F-VTND Manual .
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system MITSUBISHI GT2510F-VTND MES Interface Function Manual MITSUBISHI GT2510F-VTND MES Interface Function Manual.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two or more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly MITSUBISHI GT2510F-VTND MES Interface Function Manual. 1 channels for aanalog RGB output GT2510F-VTND .
Applicable model: GT16. Cable length: 3 meters.
QnACPU GOT.
RS-422 conversion (FA-CNV / CBL) cable GOT.
The serial communication module GOT.
The peripheral machine connection module (AJ65BT-G4-S3) GOT.
[D-sub 25 pin loose line (row 5 pin interface terminal)] GT2510F-VTND Manual .
GT2103-PMBD does not support Q00JCPU, Q00CPU, CPU Q01CPU direct connection.
Applicable model: GT21.