INVERTER FR-A842-10940-2-60 PLC FUNCTION Manual MITSUBISHI FR-A842-10940-2-60 Programming Manual

Output points: 16 points.
Transistor output large current. MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 250kw.
SLD converter rated current: 547A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
The motor efficiency is not changed in the previous optimal excitation control,
At the same time, the newly developed advanced optimal excitation control can obtain larger torque at startup FR-A842-10940-2-60 Manual FR-A842-10940-2-60
No need to adjust the parameters (plus deceleration time or torque, etc.), in a short time to speed up to a certain speed,
Can be carried out to maximize the efficiency of energy-saving drive motor.
The automatic tuning function of the loop constant of the motor is not consistent with the constant of the motor, the motor of other manufacturers, and the length of wiring is too long,
Optimum operating characteristic drive motor FR-A842-10940-2-60 Manual .
In the state of the sensor can not only drive the high efficiency and energy saving motor and PM motor (MM-EFS), but also can drive other companies induction motor and PM motor (permanent magnet synchronous motor).
Other manufacturers of induction motors, can also be automatically tuned to achieve the best excitation control, thus expanding the use of energy saving FR-A842-10940-2-60 Manual . Memory format: EEPROM.
Number of steps: up to 16000 steps can be used.
Battery support: do not.
Method for writing and deleting: the device is installed on the PLC, and is written and deleted by the peripheral device MITSUBISHI FR-A842-10940-2-60 Programming Manual.
Note: built-in extension. 5 in each package MITSUBISHI FR-A842-10940-2-60 Programming Manual.
Application: to protect the surface of the display, to prevent the operation of oil or other material pollution.
The contaminated part of the adhesive film can be replaced.
Specifications: 120*92mm.
Application Series: F940GOT, hand held GOT. MITSUBISHI inverter series: FR-A820.
Voltage level: three phase 200V MITSUBISHI FR-A842-10940-2-60 Programming Manual.
Power: 22kw.
SLD converter rated current: 125A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Parameters can be selected by 4 different rated current and different overload rating (SLD (ultra light load) rated, LD (light load) rating, ND (general load) rating, HD (weight).
Type load) for selection.
You can choose the most suitable frequency converter for use; and by selecting a transducer with a SLD or LD rated level,
Be able to reduce the size of the device (compared with the FRR-A700 series, to reduce the volume of equipment) FR-A842-10940-2-60 PLC FUNCTION.
For applications that require high torque at low speeds, the HD rating is the most suitable.
The controller is used to control and monitor the frequency converter through the network FR-A842-10940-2-60 Manual .
Standard corresponding RS-485 communication (MITSUBISHI converter protocol, Modbus-RTU protocol) data transmission speed up to 115200bps.