INVERTER FR-E740-5.5K-CHT Applied Manual MITSUBISHI FR-E740-5.5K-CHT Instruction manual

The largest input / output points: 20 points.
Power supply voltage: 24VDC.
Input points: 12 points.
Output points: 8 points.
Output type: Transistor (source).
Power consumption (W): 7.
Weight (kg):0.3.
Size (WxHxD) mm:75x90x49.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, the output points are less than 14 FR-E740-5 FR-E740-5.5K-CHT5K-CHT Manual .
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simple manipulator.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0.
FX1S provides up to 30 I/O points, and can be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment FR-E740-5.5K-CHT Manual . Total input and output points: 48 points.
Input points: 24 points.
Output points: 24 points.
Output type: transistor output.
Power supply voltage: DC24V.
Input signal voltage: DC24V.
FX2N series expansion unit
Expansion unit is an input and output expansion device with a built-in power supply FR-E740-5.5K-CHT Manual .
As with the basic unit, the extension unit can be connected to a variety of input and output and special extension equipment.
Can connect to FX3GA/FX3G, FX3GE and FX3U.
AC power model, the built-in maximum DC24V 250mA/460mA supply power MITSUBISHI FR-E740-5.5K-CHT Instruction manual.
Because all models of FX series are built in high speed counter,
So the high speed control can be realized by the simple procedure MITSUBISHI FR-E740-5.5K-CHT Instruction manual.
The input of the basic unit is built in the anti jitter filter,
One part as digital filter,
Sensitivity adjustment unit can reach 1ms.
Using high speed counter automatically adjusted to the minimum value.
Through the high cost of the built-in positioning function and the expansion function to increase the number of control axis MITSUBISHI FR-E740-5.5K-CHT Instruction manual.
Extended function expansion board and special adapter,
Data links and communication with external serial devices. Input / output mode: transistor output (drain).
Output points: 16 points.
DC5V internal consumption current:: 100mA FR-E740-5.5K-CHT Applied.
DC24V internal consumption current: 125mA.
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion modulee: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points FR-E740-5.5K-CHT Manual .