M700V Series Manual MITSUBISHI CNC M700V Series Machining Center System Programming Manual

The length of the line: 30m.
IP level: IP67.
Bending life: high bending life.
Encoder cable for HF-KP/HF-MP/HF-SP/HF-JP/HC-LP/HC-UP series. 1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 2.0kw.
Interface: SSCNET III /H.
Power supply: three phase AC200V MITSUBISHI CNC Programming Manual.
Special specification: support for CC-LinkIE.Field network motion control M700V Series
Servo amplifier supporting IE Field CC-Link network.
Ethernet based open network, support for motion control.
2 low frequency vibration can be suppressed at the same time by supporting the seismic algorithm of 3 inertial equipment.
Configurator2 MR to achieve convenient adjustment.
Effectively restrain the low frequency aftershock effect produced by the front end of the boom or the main body of the device 100Hz MITSUBISHI CNC Programming Manual.
Can effectively shorten the time to control the stability of the aftershock.
In the XY design of trajectory control, improve the accuracy of arc track.
At the same time, it can effectively control the phenomenon of quadrant protrusion caused by the rotation direction of the servo motor, which is caused by friction and twisting MITSUBISHI CNC Programming Manual. MITSUBISHI general purpose AC servo amplifier MR-J2 series.
Rated output: 2.0kw.
Interface: general purpose interface.
Voltage: three phase AC200V.
MITSUBISHI servo system in the MITSUBISHI servo amplifier is widely used,
It can not only be used in the high precision position control and speed control of the working machinery and general industrial machinery,
Can also be used in the field of speed control and tension control M700V Series Programming Manual M700V Series Programming Manual.
By installing a personal computer with a servo setting software, the parameters setting, trial run, state display, and gain adjustment are performed.
MITSUBISHI servo system MR-J2S column is developed on the basis of the servo MR-J2 series with a higher performance and more features of the MITSUBISHI servo system,
The control modes are position control, sppeed control and torque control, as well as the switching control mode among them M700V Series Programming Manual M700V Series Manual. The length of the line: 5M.
IP level: IP65.
Cable lead out direction: motor shaft different side.
BBending life: high bending life MITSUBISHI CNC Programming Manual.
The cable is not shielded.
Encoder with cable (motor side); for HF-KP/HF-MP series (motor shaft with side extraction).