MITSUBISHI FR-F520J-0.4K to 15K(F) Manual FR-F520J-0.4K to 15K(F) BASIC INSTRUCTION MANUAL

Axis of control: 1.
Interpolation: No.
Program memory: built-in 3.8k step EEPROM.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
Not only can deal with single speed positioning and positioning,
Can also carry on the multi section fast operation and so on complex control FR-F520J-0.4K to 15K(F) INSTRUCTION MANUAL.
Can not be connected to the PLC, while running alone FR-F520J-0.4K to 15K(F)
1 can control 1 axes,
FX1N, FX2N, PLC FX3U up to 8 units can be connected,
PLC FX2NC up to 4 units can be connected,
FX3UC PLC can connect up to 7 units, and a plurality of shafts can be independently controlled.
Can output up to 200kHz of the pulse train.
The connection function of the absolute position detection function and the manual pulse generator FR-F520J-0.4K to 15K(F) INSTRUCTION MANUAL.
Can be used in the form of flow chart programming software, visual programming. Memory format: RAM.
Number of steps: up to 16000 steps can be used.
Battery support: required.
Method for writing and deleting: the device is installed on the PLC, and is written and deleted by the peripheral device. Max input / output points: 32 points.
Supply voltage: 100 - 240VAC FR-F520J-0.4K to 15K(F) INSTRUCTION MANUAL.
Input points: 16 points.
Output points: 16 points.
Output type: Transistor (source).
Power consumption: 40VA.
Weight (kg):0.65.
Size (WxHxD) mm:150x90x87.
Developed a range of special function modules to meet the needs of different - analog I/O, high speed counter.
Positioning control to achieve the 16 axis, the pulse train output or for the J and K type thermocouple or Pt sensor developed the temperature module.
A total of 8 special function modules can be configured for each FX2n main unit.
Note recording function, Component annotation can be recorded in the program register.
Online program editor, online change the program will not lose the working hours or stop production operation.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software can monitor, upload or uninstall programs and data via modem communications
Password protection, using a eigght digit password to protect your program FR-F520J-0.4K to 15K(F) Manual.
Clock function and hour meter function, all of the PLC FX2N has a real-time clock standard.
Continuous scanning function, to define the operation cycle for the application off the continuous scan time FR-F520J-0.4K to 15K(F) Manual.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017).