MITSUBISHI FR-F720-7.5K Instruction manual INVERTER Applied Manual

Function: RS-485 communication.
CPU module connected to the front of the expansion function of the substrate.
The front of the CPU module can be connected to 1 units at most. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 3.7kw.
SLD converter rated current: 25A.
Structure and function: Standard model FR-F720-7.5K Manual .
Type: CA.
Substrate coating: have.
Compatibility with existing models FR-F720-7.5K
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation.
(rectifier separation type will vary)
Also, but also through the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station.
Built in 2 PID arithmetic FR-F720-7.5K Manual . In the inverter can be PID control of the motor state at the same time, used in the control of the external machine.
No external PID controller is used to control the external machine, so the system cost can be reduced. Output extension board (transistor output 2 point)
(FX1S and FX1N host general). MITSUBISHI inverter FR-F720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 110KW FR-F720-7.5K Manual .
When the ring is opened, the frequency converter is provided with a load of the motor when the motor is operated with a load at a given frequency,
The range of the motor speed in the rated slip ratio (1%~5%) changes.
For the requirements of relatively high precision, even if the load changes are also required to operate at a given speed of the occasion,
Inverter with PG feedback function can be used (selection) MITSUBISHI INVERTER Manual MITSUBISHI INVERTER Manual .
If the given acceleration time is too short, the output frequency of the inverter is far more than the change of the speed (electric angular frequency),
Converter will be due to flow over the current trip, the operation stopped, which is called stall MITSUBISHI INVERTER Manual . Output: 16 points.
Function: bidirectional thyristor output models.
Corresponding models: FX3GA, FX3G, FX3GE, FX3GC, FX3U, FX3UC.
CCan carry on the FX3GC, the FX3UC basic unit and the expansion module or the localization module the connector and the terminal station transformation,
Save the time of the input and output connection, realize the labor saving FR-F720-7.5K Instruction manual.

The use of built-in input and output components models,
Can receive AC100V input, or through the relay or the transistor to drive large capacity load FR-F720-7.5K Manual .