MITSUBISHI FX Configurator-EN OPERATION MANUAL FX Configurator-EN Manual

Input signal: platinum temperature resistance 3 wire 4 points.
Sensor current: 1mA.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
PT type temperature sensor input module.
Platinum temperature measurement resistor (Pt100 3 wire) temperature sensor input module FX Configurator-EN OPERATION MANUAL.
4 channels can be entered.
Unit can be set to Celsius or fahrenheit FX Configurator-EN
Resolution is 0.2~0.3 degree of high precision. Max input / output points: 48 points.
Power supply voltage: 24VDC.
Input points: 24 points.
Output points: 24 points.
Output type: relay.
Power consumption: 30W.
Weight (kg):0.85.
Size (WxHxD) mm:182x90x87.
Note recording function, Component annotation can be recorded in the program register FX Configurator-EN OPERATION MANUAL.
Online program editor, online change the program will not lose the working hours or stop production operation.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software can monitor, upload or uninstall programs and data via modem communications
Password protection, using a eight digit password to protect your program FX Configurator-EN OPERATION MANUAL.
Clock function and hour meter function, all of the PLC FX2N has a real-time clock standard.
Continuous scanning function, to define the operation cycle for the application of the continuous scan time.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017). Memory format: RAM.
Number of steps: up to 16000 steps can be used.
Battery support: required.
Method for writing and deleting: the device is installed on the PLC, and is written and deleted by the peripheral device. Power: 1.5kw.
Purpose: to suppress the power harmonics.
Improve the power factor, reduce the input side of the high harmonic current.
Make sure that this option is installed in the FR-A8220-03800 (75K) and FR-A840-02160 (75K) and above capacity and above capacity FX Configurator-EN Manual.
At the same time the installation options in the use of 75kW and above motor. (the IP55 series has a built-in DC reactor.)
According to the motorr power used to select the DC reactor FX Configurator-EN Manual.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.)