MITSUBISHI FX0S Series DET NORSKE VERITAS FX0S Series DNV

PC-9800 computer (D-SUB 25 pin)Extended power supply for CPU module with built-in power supply.
Bus conversion module is required when using. Maximum can be connected to 2 sets. Can be isolated to obtain DC24/48/100V, AC100/200V input signal.Max input / output points: 10 points.
Supply voltage: 100 - 240VAC FX0S Series DET NORSKE VERITAS.
Input points: 6 points.
Output points: 4 points.
Output type: relay FX0S Series
Power consumption (W): 19.
Weight (kg):0.22.
Size (WxHxD) mm:60x90x49.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types.
This type of PLC is mainly used in all of the digital input, digital output control point of the device.
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain FX0S Series DET NORSKE VERITAS.
The series transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor.
The series PLC can not be brought with the expansion module, but can be installed by the BD board to extend a small amount of I/O.
The series 1N through the installation of BD series PLC board, can achieve RS232, RS485, RS422 communication FX0S Series DET NORSKE VERITAS. Through a series of holes available to install FR-A800 using the original FR-A500 series.Memory format: flash memory.
Number of steps: up to 64000 steps.
Battery support: do not.
Write, delete method: installed on the PLC through the peripheral devices to write, delete.
Note: with program transfer function. MITSUBISHI inverter FR-F740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 560KW.
The main circuit of the inverter can be divided into two categories in general: voltage type is the voltage source of the DC converter for AC inverter,
The filtering of the DC circuit is the capacitance; the current mode is the DC conversion of the current source to the AC inverter,
The DC loop filter is the inductor.
Why is the frequency of the inverter voltage proportionnal to the change?
The electromagnetic torque of any motor is the result of the interaction between the current and the magnetic flux, the current is not allowed to exceed the rated value, otherwise it will cause the heating of the mmotor FX0S Series DNV FX0S Series DNV.
Therefore, if the magnetic flux decreases, the electromagnetic torque will decrease, which leads to the reduction of the load carrying capacity.