MITSUBISHI FX3G-40MR/DS Basic & Applied Instructions Edition PROGRAMMING MANUAL

Voltage level: three phase 400V.
Applicable motor capacity: 450kw.
Substrate coating: have.
Built in DC reactor.
The operating frequency of the fixed alternating current is converted to DC power. Total input and output points: 8 points.
Output points: 8 points.
Output type: transistor output.
FX Series in the compact body built in superior performance, and strive to operate simple FX3G-40MR/DS Basic & Applied Instructions Edition FX3G-40MR/DS
In addition, rich options can meet the various needs of customers.
In the virtual factory will be rich in the function of a part of the introduction.
It is easy to control the analog quantity of the application.
Can be extended to all models in the FX series analog devices.
Function extension board, special adapter without programming can be used for communication FX3G-40MR/DS Basic & Applied Instructions Edition.
FX2N extension module.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V FX3G-40MR/DS Basic & Applied Instructions Edition.
The number of connection points depends on the basic unit and the expansion unit. Power: 2.2kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor.
The installation of thermal relay, to avoid overheating and burn the brraking resistor FX3G-40MR/DS PROGRAMMING MANUAL. Power: 7.5kw.
Purpose: to suppress the power harmonics.
Connected to the inverter input, can be used to improve the power factor, reduce the input side of the high harmonic current.
According to the mmotor power used to select AC reactor FX3G-40MR/DS PROGRAMMING MANUAL.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.)