MITSUBISHI FX3U-128MT/ESS Manual FX3U-128MT/ESS Hardware Edition USER'S MANUAL

Power: 2.2kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor FX3U-128MT/ESS USER'S MANUAL.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table FX3U-128MT/ESS
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor FX3U-128MT/ESS USER'S MANUAL.
The installation of thermal relay, to avoid overheating and burn the braking resistor. Can be isolated from the output of the programmable controller, the a/b/c contact relay, SSR, Tr output.Analog input points: 4 channels
Voltage input range: DC0~10V.
Current input range: DC-20~20mA.
High precision analog input module with resolution of 11 bit binary + sign 1 bit, 10 bit binary + symbol 1 bit FX3U-128MT/ESS USER'S MANUAL.
Can be 4 channel voltage input, or current input. Power: 55kw.
Voltage: 200V.
Purpose: high frequency braking resistor.
The braking ability provided by the braking capacity is larger than that provided by the external braking resistor.
Can also be connected without built-in brake transistor inverter.
Three types of discharge resistors are available.
Please select according to the required braking torque. Total input and output points: 16 points.
Output points: 16 points.
Output type: relay output.
FX Series in the compact body built in superior performance, and strive to operate simple.
In addition, rich options can meet the various needs of customers.
In the virtual factory will be rich in the function of a part of the introduction.
It is easy to control the analog quantity of the application.
Can be extended to all models in the FX series analog devices.
Function extension board, special adapter without programming can be used for communication.
FX2N extension module.
The expansion module is an input and output expansion device off the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect FX3U-128MT/ESS Manual.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V FX3U-128MT/ESS Manual.
The number of connection points depends on the basic unit and the expansion unit.