MITSUBISHI GT1020-LWDW2 Connection Manual

Cable length: 1.2m.
For the connection between QCPU and GOT.
For connection between two GOT.
Applicable models: GT16, GT15, GT11, GT27, GT25. 1GB flash ROM.
Applicable models: GT16, GT15, GT11, HandyGOTGOT2000/1000 series with IE CC-Link field network communication module.
GOT communication module supporting IE CC-Link field network GT1020-LWDW2 .
Can be used as the IE CC-Link field network of intelligent equipment station, to construct the system containing the display GT1020-LWDW2
Support for the GOT model GT27, GT16, GT15. Protective film for 12.1 inch screen.
Scrub (frame: white), 5.
Applicable model: GT15. Protective film for 10.4 inch screen.
Scrub, 5.
Applicable model: GT16. Cable length: 0.6m.
For the connection between QCPU and GOT GT1020-LWDW2 .
For connection between two GOT.
Applicable models: GT16, GT15, GT11, GT27, GT25. Cable length: 10m.
For connection between QnA/A/FXCPU (D-SUB25 pin connector) and GOT.
Connection between serial communication unit (AJ71QC24-R4) and GOT.
Applicable models: GT10, GT21. Protective film for 5.7 inch screen.
Scrub, 5.
Applicable model: GT15. A series of high performance models that are widely used in network or single machine work environments GT1020-LWDW2 .
Screen size: 10.4 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: VGA (640 x 480).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system GT1020-LWDW2 Connection Manual.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT1020-LWDW2 Connection Manual.