MITSUBISHI GT1265-VNBA Manual GT1265-VNBA Gateway Functions Manual

Cable length: 5.0m.
For the connection between QnAS/AnSCPU/ motion controller A7GT-CNB (A Series) and CPU.
Applicable models: GT16, GT15, GT11. Cable length: 5m.
The connection between the CC-LINK interface unit and the smart GOT.
Applicable model: HandyGOT. "Accessories for 10.4 inch models.
Applicable models: GT16, GT15 GT1265-VNBA Gateway Functions Manual. "8GB flash ROM.
Applicable models: GT16, HandyGOTFor analog RGB input 2CH (1ch individual display) GT1265-VNBA
Applicable model: GT27. For the QCPU (Q mode) / transport controller CPU (Q Series) bus connection (2 channel) unit standard model.
Applicable models: GT15, GT16, GT27, GT25. Cable length: 3.0m.
For QnA/ACPU/ motion controller CPU (A series, extended basis system) and the connection between GOT GT1265-VNBA Gateway Functions Manual.
Applicable models: GT16, GT15, GT11. Cable length: 3m.
For QnA/ACPU/ motion controller CPU (A Series) /FXCPU. Connection between (D-SUB25 pin connector) and GOT.
For the connection between FA-CNV*CBL and GOT.
Connector for serial communication unit and GOT.
For the connection between AJ65BT-G4-S3 and GOT.
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21 GT1265-VNBA Gateway Functions Manual. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 8.4 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: VGA (640 x 480).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re callibrated to the touch screen system GT1265-VNBA Manual .
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT1265-VNBA Manual .