MITSUBISHI GT2512-STBD Connection Manual GRAPHIC OPERATION TERMINAL Non-Mitsubishi Products 2 Manual

Cable length: 3m.
The connection between Q/LCPU and GOT/ personal computer /GTSoftGOT1000 (D-SUB9).
Applicable models: GT16, GT15, GT11, GT10, GT27, GT25, GT23, GT21. Protective film for 8.4 inch screen.
Transparent (frame: white), 5.
Applicable model: GT15. Function: high performance and low price in the middle end model GT2512-STBD Manual .
Picture size: 10.4 inches.
Resolution: VGA.
Display: TFT color GT2512-STBD
Open frame type.
Panel color: white.
Power type: DC24V.
Middle end model of high performance and low price.
GT25 standard supports SD memory card and standard equipped with Ethernet, RS-232, RS-422/485, host/device USB interface.
Even in the log, script, alarm, soft component data transmission, such as high load processing period, but also to achieve smooth operation of the screen GT2512-STBD Manual .
Connect GOT front USB interface and computer,
Can be through the FA, the GOT machine programming, start and adjust the operation,
Save the trouble of opening the control cabinet and changing the cable.
1, USB interface: device USB machine (Mini-B USB)
Can connect to the computer to transfer data.
2, USB interface: host USB (USB-A)
USB data can be transmitted through the USB memory or read log data, such as the GOT data, but also can be connected to the use of the mouse, keyboard GT2512-STBD Manual .
3, the extension of the interface
Communication module and optional module can be installed.
4, Ethernet interface
Up to 4 different manufacturers can be connected at the same time
FA machine MITSUBISHI GRAPHIC OPERATION TERMINAL Manual .
5, RS-232 interface
Can connect all kinds of FA machine, bar code reader, serial printer MITSUBISHI GRAPHIC OPERATION TERMINAL Manual .
6, RS-422/485 interface
Can be connected to a variety of FA machines, bar code reader.
7, SD memory card slot
Can save alarm and log data, such as a large number of data. A series of high performance models that are widely used in network or single machine work environments MITSUBISHI GRAPHIC OPERATION TERMINAL Manual .
Screen size: 12.1 inches.
Display color: 256 color or more color.
Installation type: compatible with video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re callibrated to the touch screen system GT2512-STBD Connection Manual.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT2512-STBD Manual .