MITSUBISHI GT2708-STBA-GF Manual GT2708-STBA-GF Utility User's Manual

Cable length: 1m.
The connection between the FXCPU (MINI-DIN8 pin connector) and the graphic operation terminal.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT.
The unit can not be used with FX1NC, FX2NC, FX3UC-D/DSS, FX3G.
Applicable models: GT10, GT21 GT2708-STBA-GF User's Manual. Protective film for 12.1 inch screen.
Transparent (frame: white), 5 GT2708-STBA-GF
Applicable model: GT15. Cable length: 1 meters.
FXCPU GOT.
FXCPU communication function expansion board GOT.
[MINI-DIN 8 pin loose line (row 5 pin interface terminal)].
Applicable model: GT21. 2GB flash ROM.
Applicable models: GT16, GT15, GT11, HandyGOTA series of high performance models that are widely used in network or single machine work environments GT2708-STBA-GF User's Manual.
Screen size: 5.7 inches.
Display color: monochrome.
Mounting type: panel mounting type.
Resolution: QVGA (320 x 240).
Display device: STN monochrome.
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB) GT2708-STBA-GF User's Manual.
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two or more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system ccan not be used properly GT2708-STBA-GF Manual . Cable length: 1m.
Can be used when the GT15-C / EXSS-1 and GT15-C / BS combination.
Applicable models: GT16, GT15, GT11. For the GT1665M-STB.
Applicable model: GT16. Cable length: 3m.
For connection bbetween QnA/A/FXCPU (D-SUB25 pin connector) and GOT GT2708-STBA-GF Manual .
Connection between serial communication unit (AJ71QC24-R4) and GOT.
Applicable models: GT10, GT21.