MITSUBISHI MR-J2S-60CP INSTRUCTION MANUAL SERVO AMPLIFIER Manual

Type: MR-J_B series.
Rated output: 0.2KW.
Interface: standard.
Servo system according to the system structure can be divided into open loop servo system, closed loop servo system, semi closed loop system, compound control system.
The closed loop automatic control system with feedback is composed of a position detecting part, a deviation amplifying part, an executing part and a controlled object MR-J2S-60CP Manual MR-J2S-60CP
Servo system must have good controllability, high stability and high adaptability.
Note that the control of the signal is good after the disappearance of the signal, can immediately stop the turn;
High stability is the torque with the increase of speed and uniform decline; adaptability is fast, sensitive, and ring state quality is good MR-J2S-60CP Manual.
According to the types of servo drives are classified, there are three kinds of electric, hydraulic or electric hydraulic.
If the servo system is divided according to the function, then there is a measuring servo and power servo system;
Analog servo and power servo system; position servo and acceleration servo system.
The electric servo system can be divided into two categories: DC DC servo system and AC AC servo system based on the electrical signals MR-J2S-60CP Manual.
AC AC servo system also has two kinds of asynchronous motor servo system and synchronous motor servo system. Power: 220kw.
Voltage: 200V.
Sine wave filter.
The voltage and current of the motor can be adjusted to a sine wave MITSUBISHI SERVO AMPLIFIER Manual.
The sine wave filter is installed to the output terminal of the inverter MITSUBISHI SERVO AMPLIFIER Manual.
Applicable to FR-A820-03800 (75K) above and FR-A840-02160 (75K) and above frequency converter.
Sine wave filter is equivalent to the operational characteristics of the sine wave power driver, can provide the following benefits.
Low noise.
No surge current.
Reduce motor loss (standard motor). "MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series MITSUBISHI SERVO AMPLIFIER Manual.
Rated output: 1.0kw.
Built in positioning function.
Voltage: 3 phase AC200VAC or single phase AC230V.
Compatible with "MR-J2S- CP-S084" - servo amplifier and interface unit "MR-J2S-TO1" positioning by CC--Link
Simply setting the point table MR-J2S-60CP INSTRUCTION MANUAL.
AC servo can be used as the driving source of the field network.
Using servo amplifier built-in positioning function, position data and speed data, you can set the CC-Link.
Start, stop and dissplay can also be transmitted through the CC-Link MR-J2S-60CP Manual.
Serial communication reduces wiring.
AC servo distributed control system can be easily constructed. "