MITSUBISHI MR-J2S-700B4 SUPPLEMENTARY INSTRUCTION MANUAL SERVO AMPLIFIER Manual

Drive: MR-H_ACN series CC-LINK features.
Rated output: 2.0KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions MR-J2S-700B4 Manual.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data MR-J2S-700B4 Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relatively small volume,
And the measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive MR-J2S-700B4 Manual.
Usually, such testing system is only used to test the rotational speed and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive. Cable length: 2m.
For MR-J2S-700A (4) /CP/CL or less MR-J2S-700B4 Manual.
Encoder for HC-KFS; HC-MFS; 3000r/min HC-UFS servo motor.
-H products have a long flex life. MR-J3-BS by installing security logic unit MR-J3-D05, can be achieved to stop class 1 (SS1) function.
STO and SS1 features of the security level of IEC/EN 61508 SIL 2, SILCL2 EN62061 and ISO 13849-1 EN PL D (3 categories) MITSUBISHI SERVO AMPLIFIER Manual.
MR-J3- - BS - standard connection diagram.
When using MR-J3-D05.
The connection mode is different from the supply voltage MITSUBISHI SERVO AMPLIFIER Manual.
Main circuit / control circuit power supply connection. 1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 11.0kw.
Interface: SSCNET III /H.
Power supply: three phase AC200V.
Special specification: support for CC-LinkIE MITSUBISHI SERVO AMPLIFIER Manual. Field network motion control.
Servo amplifier supporting IE Field CC-Link network.
Ethernet based open network, support for motion control.
Improve mechanical properties by high performance motor.
By improving the resolution and processing speed of the encoder,
The rotating servo motor has hiigher precision and better performance of rotation MR-J2S-700B4 SUPPLEMENTARY INSTRUCTION MANUAL.
Only open a key type of adjustment function, can be carried out including mechanical resonance filter, high end seismic control II, low pass filter servo gain adjustment.
Easilyy start advanced seismic function, it can maximize the mechanical properties MR-J2S-700B4 Manual.
It can automatically adjust the required response settings automatically.