MITSUBISHI MR-J3-10T Manual MR-J3-10T CC-Link INSTRUCTION MANUAL

MR-J2M multi axis servo amplifier drive unit.
Rated output: 0.2kw.
AC servo control system includes AC servo system based on asynchronous motor and AC servo system based on synchronous motor.
Besides the advantages of good stability, good rapidity and high accuracy, the advantages of.
Its performance indicators can be measured from the speed range, positioning accuracy, the accuracy of stability, dynamic response and operational stability and so on MR-J3-10T INSTRUCTION MANUAL MR-J3-10T Superior high efficiency IPM motor.
Output power: 11kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time MR-J3-10T INSTRUCTION MANUAL. Fiber length: 0.15 meters.
SSCNET III cables (standard optical fiber used in control cabinet).
Joints for CN1A and CN1B. Cable length: 30m.
For MR-J2S-700A (4) /CP/CL or less.
Encoder for HC-KFS; HC-MFS; 3000r/min HC-UFS servo motor.
-L represents bending life. A set of power connectors for use in
HC-SFS702; 7024.
HA-LFS702.
For MR-J2S-11KA (4) MR-J2S-22KA to (4) MR-J3-10T INSTRUCTION MANUAL. Superior high efficiency IPM motor.
Output power: 55kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time. Cable length: 0.5M. Used in MR-J2S-700B (4) or lessType: MR-J series.
Rated output: 0.2KW.
Suitable for motor series: HA-ME.
Voltage: three phase AC220V.
It is very helpful to improve the stability of the low speed control of the servo motor.
But there is no direct effect to improve the accuracy of position control.
There are, of course, software compensation that is similar to pitch compensation,
Can improve the physical resolution of the single lap, so as to improve the accuracy of positioning control.
This can be effectively used in the use of the robott control of the indexing table MR-J3-10T Manual.
It is also because of the application of splicing technology,
The rotary encoder will be more widely used in the high precision servo control in the harsh environment.
The use of rotary encoder with 224/ in the servo motor has been used in the servo motor MR-J3-10T Manual.
Encoder serial communication system, the communication frequency can only be limited to 10M.