OMRON CP1L-L14DT-A REFERENCE MANUAL PLC Communications Commands Manual

Supply voltage: 100 to 120 or 200 to 240 VAC, 50/60 Hz
Output capacity: DC5V, 6.5AModel: C200HW-PA209R.
Supply voltage: 100 to 120 VAC, 200 to 240 VAC.
Comments: With output contacts during operation.Output type: Relay.
Inputs points: 12 points.
Outputs points: 8 points.Number of outputs: 8 pts.
Input Voltage: 250 VAC, 24 VAC CP1L-L14DT-A Manual.
Max Switching Current: 2 Amps.
Common Type: Independent CP1L-L14DT-AOutput method: Transistor sourcing.
Inputs: 12.
Outputs: 8.Name: Three-tier Screw Terminal Block.
Specifications: Outputs; 8 outputs; PNP;
With Short-circuit and,
Disconnected Line Detection.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet CP1L-L14DT-A Manual.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error CP1L-L14DT-A Manual. Model: C200H-OD411.
No. of points: 8 pts.
Specifications: 1A, 12 to 48 VDC.Unit classification: CJ1 Special I/O Units.
Product name: Position Control Units,
(High Speed type).
Specifications; Control method/Control,
output interface: Pulse-train open-collector,
output with Pulse Counter Function;
Number of control axes : 2 axes OMRON PLC Manual.
No. of unit numbers allocated: 2 OMRON PLC Manual.
Current consumption: 5V, 0.27A; 24V, --.
Standards: UC1, CE.
Motion Control Capabilities with Unit,
Synchronization and Even Higher Speed.
Models are available with 2 or 4 axes,
and open-collector or line-driver outputs.
The CJ1W-NC214/NC414 have open-collector outputs,
and the CJ1W-NC234/NC434 have line-driver outputs OMRON PLC Manual.
Control 2 or 4 Axes High-speed, high-resolution,
position control is possible for servomotors ,
and pulse motors, and even linear motors,
and direct drive motors. CPU Unit: CP1L-L CPU Units with 20 Points.
Specifications: CPU type, Memory capacity: 5K steps
High-speed counters: 100 kHz, 4 axes Pulse outputs:
100 kHz, 2 axes (Models with transistor outputs only);
Power supply, DC power supply; Output method,, Transistor output (sourcing);
Inputs, 12; Output, 8 CP1L-L14DT-A REFERENCE MANUAL.
Standards: UC1, N, L, CE.
High Performing Programmable Controller with Embedded Ethernet.
"CP1L-EM" and "CP1L-EL" has a standard-feature Ethernet port.
"CP1L-M" and "CCP1L-L" has a standard-feature peripheral USB port CP1L-L14DT-A Manual.
Function blocks (FB) allow you to build up modular structure and,
programming of ladder diagrams.