PLC A171SCPU-S3 Dedicated Instructions Manual MITSUBISHI A171SCPU-S3 Programming Manual

Cable length 5m; used in A6TE2-16SRN.Input and output points: 1024 points.
Input / output data points: 1024 points.
Program capacity: 14K.
Basic command processing speed (LD command) s:1.0.
AnNCPU command processing time and ACPU compare to 10-20% high speed processing.
User program storage capacity: it is a measure of how much the user application can store the number of indicators A171SCPU-S3 Manual A171SCPU-S3
Usually in words or K words as units. 16 bit binary number is a word,
Every 1024 words are 1K words. PLC to store instructions and data in words.
General logical operation instructions each account for 1 words. Timer / counter,
Shift instruction accounted for 2 words. Data operation instructions for 2~4.
Integral type: the PLC components are installed together or a few pieces of printed circuit board,
And together with the power supply installed in the casing to form a single overall called the host or the basic unit, small, ultra small PLC using this structure A171SCPU-S3 Manual .
Modular: PLC is the basic components of a separate module.
Medium and large PLC used this way. Easy maintenance. Input and output points: 512 points A171SCPU-S3 Manual .
Input / output data points: 512 points.
Program capacity: 14K.
Basic command processing speed (LD command) s:0.20.
Each scanning process. Focus on the input signal sampling. Focus on the output signal to refresh.
Input refresh process. When the input port is closed,
Program in the implementation phase, the input end of a new state, the new state can not be read MITSUBISHI A171SCPU-S3 Programming Manual.
Only when the program is scanned, the new state is read MITSUBISHI A171SCPU-S3 Programming Manual.
A scan cycle is divided into the input sample, the program execution, the output refresh.
The contents of the component image register are changed with the change of the execution of the program.
The length of the scan cycle is determined by the three.
CPU the speed of executing instructions MITSUBISHI A171SCPU-S3 Programming Manual.
Time of instruction.
Instruction count.
Due to the adoption of centralized sampling.
Centralized output mode.
There exist input / output hysteresis phenomena, i.e., the input / output response delay.
User program storage capacity: it is a meassure of how much the user application can store the number of indicators A171SCPU-S3 Dedicated Instructions.
Usually in words or K words as units. 16 bit binary number is a word,
Every 1024 words are 1K words. PLC to store instructions and data in words.
General llogical operation instructions each account for 1 words A171SCPU-S3 Manual . Timer / counter,
Shift instruction accounted for 2 words. Data operation instructions for 2~4.