PLC FX2N-48MT-E/UL Manual MITSUBISHI FX2N-48MT-E/UL PROGRAMMING MANUAL II

Input points: 32 points.
Power supply: the basic unit to the expansion module to provide power.
Terminal type: connector type.
Weight: 0.2kg.
FX3GC, FX3UC can be directly connected to the input and output expansion equipment, to achieve a compact expansion.
Can choose 16 points, 32 points of the relay or transistor input and output models FX2N-48MT-E/UL Manual.
FX2NC-16E_-T-DS for terminal units can be disassembled models FX2N-48MT-E/UL Function: CPU module (internal service power supply).
Input and output points: 32 points.
Power supply capacity (DC5V power): 900mA.
Power supply capacity (DC24V service power supply): 400mA.
Input / output mode: DC input (drain / source) / transistor (drain).
Input points: 16 points.
Output points: 16 points FX2N-48MT-E/UL Manual.
The new expansion module is more convenient!
Pioneer products with advanced built-in functions and rich extensibility.
FX5U built-in analog, communication, high speed input and output,
By extending the board and adapter can be easily extended system.
In addition, through the high speed system bus,
Can maximize the role of the built-in intelligent functions of the expansion device FX2N-48MT-E/UL Manual.
Function extension board for RS-422 communication.
DC5V power consumption: 20mA. The number of output channels: 4 channels.
Voltage output: DC-10~10V.
Current output: DC0~20mA, DC-4~20mA.
Programmable logic controller: FX2NC, FX3UC.
By using analog input module and output module,
Can be input and output analog (voltage, current, etc MITSUBISHI FX2N-48MT-E/UL PROGRAMMING MANUAL II. ).
Indispensable analog control in FA control,
It is easy to implement on a programmable logic controller MITSUBISHI FX2N-48MT-E/UL PROGRAMMING MANUAL II. Function expansion board for RS-485 communication.Power: 45kw.
Purpose: to suppress the power harmonics.
Connected to the inverter input, can be used to improve the power factor, reduce the input side of the high harmonic current.
According to the motor power used to select AC reactor MITSUBISHI FX2N-48MT-E/UL PROGRAMMING MANUAL II.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.) Power: 0.4kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor too reach 300 degrees C or higher, it is necessary to take protective measures and cooling FX2N-48MT-E/UL .
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between thhe short circuit chip, in addition to connecting the DC reactor FX2N-48MT-E/UL Manual.
The installation of thermal relay, to avoid overheating and burn the braking resistor.