PLC FX2NC Series Manual MITSUBISHI FX2NC Series PROGRAMMING MANUAL

Input and output points: 20 points.
Power supply: AC100-240V.
Input points: 12 points.
Output points: 8 points.
Output form: relay output.
Power consumption: 20W.
Weight: 0.4KG.
Outline dimension: 75x90x75mm.
A new application model.
FX3SA is a basic model on the basis of the basic performance of FX1S above the expansion of the expansion of the new model FX2NC Series Manual.
FX3SA is applicable to all kinds of fields of small scale equipment which need to simulate the quantity and function of MODBUS and Ethernet FX2NC Series
Basic models suitable for small scale control.
Compact but powerful,
At the same time, the analog quantity and communication function, etc.. Power: 3.7kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted FX2NC Series Manual.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling FX2NC Series Manual.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor MITSUBISHI FX2NC Series PROGRAMMING MANUAL.
The installation of thermal relay, to avoid overheating and burn the braking resistor MITSUBISHI FX2NC Series PROGRAMMING MANUAL. Length: 1.5m.
Specification: TB-FX round cable. Function: simple motion control 4 axis positioning (corresponding to SSCNET III /H).
Input and output points: 8 points.
Positioning control via /H III SSCNET.
FX5-40SSC-S is equipped with the corresponding SSCNET III /H 4 axis positioning function module MITSUBISHI FX2NC Series PROGRAMMING MANUAL.
Table operation, combined with linear interpolation, circular interpolation between the 2 axes, and the connection trajectory conttrol,
Smooth positioning control can be easily realized FX2NC Series .
Positioning function of 8CH high speed pulse input and 4 axis pulse output by FX5U/FX5UC.
In addition, the high speed output can be set through the table, which can be reallized through special instructions, which can be used to realize the function of interrupt location, variable speed operation and simple interpolation FX2NC Series Manual.