PLC FX3U-32MT/DS Basic & Applied Instructions Edition Manual MITSUBISHI FX3U-32MT/DS PROGRAMMING MANUAL

Power: 55kw.
Voltage: 200V.
There are 100% braking torque output in continuous regeneration, which can correspond to the continuous regeneration operation of the pipeline control.
There is no need to install the braking unit for each frequency converter, which can reduce the comprehensive space and reduce the comprehensive cost FX3U-32MT/DS Manual.
Renewable energy can be used for other frequency converter, excess energy back to the grid, to achieve energy saving FX3U-32MT/DS Convert connector to screw relay terminal.
According to the location of the connection equipment distribution module. The terminal row is converted to e-CON.Voltage level: three phase 400V.
Applicable motor capacity: 450kw.
Substrate coating: have.
Built in DC reactor FX3U-32MT/DS Manual.
The operating frequency of the fixed alternating current is converted to DC power. Uses: for external BCD or binary digital signal to do the frequency of a given.
Applicable frequency converter: FR-A700, FR-F700, FR-E700"MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 7.5kw.
SLD converter rated current: 49A.
Structure and function: Standard model FX3U-32MT/DS Manual.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation.
(rectifier separation type will vary)
Also, but also through the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station MITSUBISHI FX3U-32MT/DS PROGRAMMING MANUAL.
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same time, used in the control of the external machine MITSUBISHI FX3U-32MT/DS PROGRAMMING MANUAL.
No external PID controller is used to control the external machine, so the system cost can be reduced. Needle number: 20.
Specification: loose wire connector, 5 sets (0.3mm 2). Function expansion board for RS-485 communication MITSUBISHI FX3U-32MT/DS PROGRAMMING MANUAL. Specifications: according to the connection source.
Corresponding models: FX3GA, FX3G, FX3GE, FX3GC, FX3U, FX3UC. Extension board for connection with special adapters
(FX1S and FX1N host general). Output expansion board (transistor output 2 points).MITSUBISHI inverter FR-D720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 0.75KW.
Vector control variable frequency speed control is the practice of the asynchronous motor in the three-phase coordinate system of the stator current Ia, Ib, Ic, through the three-phase to two-phase transformation,
The alternating current of Ia1Ib1 is equivalent to a two phase stationary coordinate system, and then is rotated by the rotor field orientted,
Equivalent to the DC current Im1, It1 (Im1 equivalent to DC motor excitation current in synchronous rotating coordinate system;
It1 equal to the armature current proportional to the torque, and then imitate the DC motor conttrol method, to obtain the DC motor control,
The control of asynchronous motor is realized through the corresponding inverse coordinate transformation FX3U-32MT/DS Manual FX3U-32MT/DS Basic & Applied Instructions Edition.