PLC FX3UC-16MT/D-P4 Hardware Edition Manual MITSUBISHI FX3UC-16MT/D-P4 USER'S MANUAL

Use FX3S-CNV-ADP when connecting to the left of the basic unit of the FX3SA, FX3U, and FX3S.Power: 7.5kw.
Purpose: to suppress the power harmonics.
Improve the power factor, reduce the input side of the high harmonic current.
Make sure that this option is installed in the FR-A820-03800 (75K) and FR-A840-02160 (75K) and above capacity and above capacity FX3UC-16MT/D-P4 Manual.
At the same time the installation options in the use of 75kW and above motor FX3UC-16MT/D-P4 (the IP55 series has a built-in DC reactor.)
According to the motor power used to select the DC reactor.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.) Power: 15kw.
Voltage: 200V.
Purpose: high frequency braking resistor FX3UC-16MT/D-P4 Manual.
The braking ability provided by the braking capacity is larger than that provided by the external braking resistor.
Can also be connected without built-in brake transistor inverter.
Three types of discharge resistors are available.
Please select according to the required braking torque. MITSUBISHI inverter series: FR-F842.
Voltage level: three phase 400V.
Power: 400kw.
SLD converter rated current: 866A FX3UC-16MT/D-P4 Manual.
Structure and function: the rectification part is off type.
Type: CA.
Substrate coating: have.
Energy saving by high efficiency motor.
Reduce standby power consumption.
DC24V external power supply, the input MC signal can be stopped after the motor for the OFF, in the motor drive for the ON MITSUBISHI FX3UC-16MT/D-P4 USER'S MANUAL.
Standby power management can be carried out by means of frequency converter to realize the power consumption reduction of standby time MITSUBISHI FX3UC-16MT/D-P4 USER'S MANUAL.
According to the temperature of the inverter cooling fan, the operation of the inverter can be controlled.
According to the operating conditions of the inverter cooling fan output the corresponding signal,
Therefore, the inverter and other built-in fan and inverter cooling fan synchronous operation MITSUBISHI FX3UC-16MT/D-P4 USER'S MANUAL.
Can reduce the power consumption in the stop. RS-232C/RS-422 converterExtending the device for FX1, PLC FX2, on PLC FX2N.
Need to use the conversion cable. MITSUBISHI inverter series: FR-A820.
Voltage level: three phase 200V.
Power: 7.5kw.
SLD converter rated current: 49A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Parameters can be selected by 4 different rated current and different overload rating (SLD (ultra light load) rated, LD (light load) rating, ND (general load) rating, HD (weight).
Type load) for selection.
You can choose the most suitable frequency converter for use; and by selecting a transducer with a SLD or LD rated level,
Be able to reduce the size of the device (compared with thhe FR-A700 series, to reduce the volume of equipment) FX3UC-16MT/D-P4 Hardware Edition.
For applications that require high torque at low speeds, the HD rating is the most suitable.
The controller is used to control and monitor the frequency converter through the network FX3UC-16MT/D-P4 Manual.
Standard corresponding RS-485 communication (MITSUBISHI converter protocol, Modbus-RTU protocol) data transmission speed up to 115200bps.