PLC FX3UC-64MT/D Basic & Applied Instructions Edition Manual MITSUBISHI FX3UC-64MT/D PROGRAMMING MANUAL

A 20 pin connector is installed on one side of the loose line.
Length 5M. Function: terminal output.
Output points: 16 points.
Output form: relay.
Connected programmable logic controller: FX1NC, FX2NC, FX3UC.
Weight: 0.15KG.
FX2NC expansion module can be directly connected to the FX1NC, FX2NC, PLC FX3UC on the expansion of the input and output FX3UC-64MT/D Manual.
Do not need to connect the cable and so on, therefore can carry on the compact expansion FX3UC-64MT/D Connecting cable for handheld GOT and PLC.
Cable length: 1.5 meters.
Application: RS-422 connection (FX series). Total input and output points: 16 points.
Output points: 16 points.
Output type: silicon controlled output.
FX Series in the compact body built in superior performance, and strive to operate simple FX3UC-64MT/D Manual.
In addition, rich options can meet the various needs of customers.
In the virtual factory will be rich in the function of a part of the introduction.
It is easy to control the analog quantity of the application.
Can be extended to all models in the FX series analog devices.
Function extension board, special adapter without programming can be used for communication FX3UC-64MT/D Manual.
FX2N extension module.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V MITSUBISHI FX3UC-64MT/D PROGRAMMING MANUAL.
The number of connection points depends on the basic unit and the expansion unit MITSUBISHI FX3UC-64MT/D PROGRAMMING MANUAL. MITSUBISHI inverter FR-F720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 55KW.
When the ring is opened, the frequency converter is provided with a load of the motor when the motor is operated with a load at a given frequency,
The range of the motor speed in the rated slip ratio (1%~5%) changes MITSUBISHI FX3UC-64MT/D PROGRAMMING MANUAL.
For the requirements of relatively high precision, even if the load channges are also required to operate at a given speed of the occasion,
Inverter with PG feedback function can be used (selection) FX3UC-64MT/D Basic & Applied Instructions Edition.
If the given acceleration time is too short, the output frequency of the inverter is far more than thhe change of the speed (electric angular frequency),
Converter will be due to flow over the current trip, the operation stopped, which is called stall FX3UC-64MT/D Manual.