Q06UDHCPU Manual MITSUBISHI CPU Q06UDHCPU Multiple CPU System User's Manual

Connect to read and write 1Ch.
ID system interface module.
ID controller M-688-001/002 BIS can be installed directly to the Q series of substrates,
Control module for reading and writing ID tag data through a programmable logic controller.
The ladder diagram of M-688-002 BIS is compatible with QD35ID1/2 MITSUBISHI CPU User's Manual.
2 antennas can be connected, and the parallel processing of the 2 channels can be simultaneously carried out Q06UDHCPU
Can use all ID tags in the M BIS series.
ID series /BIS system is an industrial automation ID system which can use the electromagnetic combination method to read and write data.
ID tag has a variety of sizes and storage capacity.8 channel.
Input: DC4~20mA.
Output (resolution): 0~6400; 0~3200 MITSUBISHI CPU User's Manual.
Conversion speed: 10ms/ channel.
18 point terminal station.
Isolation between channels.
Power supply to a two wire transmitter.
The possibility of expanding control with intelligent function.
At the same time, the channel isolation analog module realizes high isolation voltage,
Further improve the accuracy of the benchmark.
Provide support for process control using a general purpose programmable controller MITSUBISHI CPU User's Manual.
Flow meter, pressure meter, other sensors can be directly connected to analog input,
Control valve can also be directly connected to analog output.
Hardware and installation costs have been greatly reduced due to the need for an external isolation amplifier Q06UDHCPU User's Manual.
High insulation strength.
Can isolate electrical interference, such as current and noise, etc Q06UDHCPU User's Manual. .
Standard analog input module.
Isolated analog input module.
No external isolation amplifier required.
Without the use of inter channel isolation analog modules.
Using the inter channel isolation analog module.Upgraded version.
Control axis: maximum 32 axes.
Manual pulse generator operation function: can use 3 sets of manual pulse generator Q06UDHCPU User's Manual.
Synchronous encoder operation function: can use 12 ssynchronous encoder Q06UDHCPU Manual.
Peripheral I/F: by CPU PLC.
High speed motion control system based on multi CPU architecture.
Multi CPU system based on Q series PLC.
Flexible selection of CPU PLC and motion CPU according to differeent applications MITSUBISHI CPU User's Manual.
In the construction of multi CPU system, can have up to 4 sets of CPU.
When 3 Q173DCPU is used, the maximum 96 axes can be controlled.