Q172HCPU Manual MITSUBISHI CPU Q172HCPU Common Instructions Strctured Programming Manual

Master / local station sharing.
Corresponding Ver2 CC-Link.
I/O control in the first class of open field network module.
CC-Link based on reliable field bus technology,
Able to transmit large number of bits data (such as ON/OFF information) and word data (such as analog information).
Consistency of CC-Link to maintain loop transmission,
And the cycle of transmission and information (instantaneous transmission) communication separately, so as to ensure the timeliness of MITSUBISHI CPU Strctured Programming Manual Q172HCPU
Even if the information reaches saturation, it will not affect the link scan time.
The QJ61BT11N module supports CC-Link version 1 and version 2, which can be used as a local station or master station module.RS232 connector conversion cable (round connector, 9 pin D-sub connector) MITSUBISHI CPU Strctured Programming Manual.
Easy connection through the hub CPU.
By using an Ethernet hub, programming tools and multiple CPU can be connected simultaneously.
Through the programming tool can be searched and displayed in the list has been connected to the CPU.
Therefore, even if the IP CPU address is unknown, just choose from this list, you can easily connect.
Seamless communication without network level constraints MITSUBISHI CPU Strctured Programming Manual.
With the latest high-speed, large capacity IE CC-Link controller network and IE CC-Link field network,
Corresponding to the increasing amount of information.
Together with previous MELSECNET/H, Ethernet and CC-Link,
These networks can be across the network type or level of differences, to achieve seamless communication Q172HCPU Strctured Programming Manual Q172HCPU Strctured Programming Manual.
Programmable logic controller on the network through the programming tool of the Ethernet connection,
Monitoring and programming."2 axes, SSCNET III type.
2 axis linear interpolation.
2 axis arc interpolation.
Control unit: mm, inch, degree, pulse.
Location data: 600 data / axis Q172HCPU Strctured Programming Manual.
40 pin connector.
Through the SSCNET III cable connection to save wiring, the distance between the station up to 50m.
Absolute position system for determining the origin position is supported by the return data set operation.
In addition, the limit switch of the upper limit, the lower limit switch and the near point block signal input can be directly connected to the servo amplifier,
Thus greatly reducing the wiring requirements.
Easy to achieve high speed, hiigh precision positioning control Q172HCPU Manual.
Support for multiple types of positioning control,
Including 2 ~ 4 axis 2 axis linear interpolation, circular interpolation, speed control and speed / position control, ppath switching control, constant speed control etc MITSUBISHI CPU Strctured Programming Manual. .
In addition, can use the "Configurator-QP GX" and other software,
Easy to set, monitor and debug. "