SERVO AMPLIFIER MR-J2-100A Communication Function Operating Installation Guide MITSUBISHI MR-J2-100A Manual

1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 15.0kw.
Interface: SSCNET III /H.
Power supply: three phase AC400V.
0.6kW and 1kW above the servo amplifier.
Servo amplifier supporting SSCNET III /H.
Complete synchronization system capable of using high speed serial optical communication MR-J2-100A Communication Function Operating Installation Guide.
Can be combined with the servo system controller to maximize the performance of the servo system MR-J2-100A
The industry''s top level speed motor, the frequency of 2.5kHz amplifier, and optical fiber network extradimensional Symphony orchestra.
Using the traditional two degree of freedom model adaptive control to further optimize the exclusive high speed servo control structure of the dedicated execution engine MR-J2-100A Communication Function Operating Installation Guide.
Achieved the fastest 2.5kHz speed frequency response in the industry.
Combined with MITSUBISHI independent research and development of high resolution absolute position encoder (4194304pulses/rev),
Greatly improve the processing speed. Can maximize the performance of high-end machinery. Superior high efficiency IPM motor.
Output power: 7.5kw.
Rated speed: 1500r/min MR-J2-100A Communication Function Operating Installation Guide.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m MITSUBISHI MR-J2-100A Manual.
1 inverters can not connect multiple IPM motors at the same time. Interface power supply: 24VDC plus or minus 10%.
Digital input: 30 points, optocoupler isolation, drain / source type support MITSUBISHI MR-J2-100A Manual.
Digital output: 16 points, optocoupler isolation, drain / source type support.
Analog input: 2 channels, 0 to plus or minus 10VDC (input impedance: 10~12k).
Analog output: 2 channels, 0 to plus or minus 12VDC. 1 axis servo amplifier MITSUBISHI MR-J2-100A Manual.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 3.5kw.
Interface: SSCNET III /H.
Power supply: three phase AC200V.
Servo amplifier supporting SSCNET III /H.
Complete synchronization system capable of using high speed serial optical communication.
Can be combined with the servo system controller to maximize the performance of the servo system.
Improve mechanical properties by high performance motor.
By improving the resolution and processing speed of the encoder,
The rotating servo motor has higher precision and better performance of rootation MR-J2-100A .
Only open a key type of adjustment function, can be carried out including mechanical resonance filter, high end seismic control II, low pass filter servo gain adjustment.
Easilyy start advanced seismic function, it can maximize the mechanical properties MR-J2-100A Communication Function Operating Installation Guide.
It can automatically adjust the required response settings automatically.