FX2N-8EX-ES/UL PDF datasheet MITSUBISHI FX2N-8EX-ES/UL datasheet PDF catalog

Power: 0.75kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor MITSUBISHI FX2N-8EX-ES/UL PDF catalog.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table FX2N-8EX-ES/UL
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor MITSUBISHI FX2N-8EX-ES/UL PDF catalog.
The installation of thermal relay, to avoid overheating and burn the braking resistor. Length: 1.5m.
Specification: TB-FX round cable. Input / output type: transistor output (source).
Output points: 16 points.
DC5V internal consumption current: 100mA.
DC24V internal consumption current: 125mA.
In order to extend the input output of the device MITSUBISHI FX2N-8EX-ES/UL PDF catalog.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion module: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points. Convert connectors to fast connectors.
According to the location of the connection equipment distribution module. Memory format: EEPROM.
Number of steps: up to 2000 steps can be used.
Battery support: do not.
Method for writing and deleting: the device is installed on the PLC, and is written and deleted by the peripheral device.
Note: the built-in program transfer function (FX1S and FX1N host generic). Max input / output points: 32 points.
Power supply voltage: 24VDC.
Input points: 16 points.
Output points: 16 points.
Output type: Transistor (source).
Power consumption: 30W.
Weight (kg):0.65.
Size (WxHxD) mm:150x90x86.
Built in CPU, power supply, input and output. By using a rich variety of functional extension boards and special adapters,
Can achieve high precision control.
Based on the function of FX2N has been greatly strengthened and enhanced.
High speed operation.
Basic instructions: 0.065 s/ instruction.
Application instruction: 0.642 s/ instruction.
Large capacity memory.
Built in program memory 64000 steps.
Flash memory cartridge with program transfer function.
Authentication。
Corresponding EN and UL/cUL authentication.
Faster and more efficient. Support high speed control and network communication, and have the function of data recording.
High speed, large capacity, multi-function high-end machine.
FX3U supports high speed processing, CC-Link communication, network communication, analog control and advanced positioning system.
Connected to the CC-Link, including the remote I/O, the maximum input and output control pointss up to 384 points,
Can correspond to a variety of field needs, the use of its scalability and flexibility to expand the scope of application of the control system FX2N-8EX-ES/UL PDF datasheet.
Third generation high function micro programmable contrroller FX2N-8EX-ES/UL PDF datasheet.
High speed, high efficiency, high performance, large capacity, and new features.
Built in high speed processing and positioning.
Control points: