FX2NC-32EYT-DSS PDF catalog MITSUBISHI FX2NC-32EYT-DSS datasheet PDF datasheet

Power: 11kw.
Purpose: to suppress the power harmonics.
Connected to the inverter input, can be used to improve the power factor, reduce the input side of the high harmonic current.
According to the motor power used to select AC reactor.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose MITSUBISHI FX2NC-32EYT-DSS PDF datasheet. ) Function extension board for RS-485 communication FX2NC-32EYT-DSS
No DC24V consumption, no occupancy of the input output (FX1S and FX1N of the host computer). Display: 16 characters x 4 lines.
Can monitor, change the value of software components.
Can also be simple to operate, change the value.
Equipped with a button operation can be used (operator certification function) and control through the PLC control function,
Can be used with the function expansion board MITSUBISHI FX2NC-32EYT-DSS PDF datasheet.
Can be installed directly to the FX3GA, FX3G, FX3GE, no wiring. Function: CPU module (internal service power supply).
Input and output points: 80 points.
Power supply capacity (DC5V power): 1100mA.
Power supply capacity (DC24V service power supply): 600mA.
Input / output mode: DC input (drain / source) / transistor (drain) MITSUBISHI FX2NC-32EYT-DSS PDF datasheet.
Input points: 40 points.
Output points: 40 points.
The new expansion module is more convenient!
Pioneer products with advanced built-in functions and rich extensibility.
FX5U built-in analog, communication, high speed input and output,
By extending the board and adapter can be easily extended system.
In addition, through the high speed system bus,
Can maximize the role of the built-in intelligent functions of the expansion device.
20 pin connector on both ends of the circular multi-core cable.
Length 1.5M. Max input / output points: 14 points.
Power supply voltage: 24VDC.
Input points: 8 points.
Output points: 6 points.
Output type: Transistor (source).
Power consumption (W): 6.5.
Weight (kg):0.22.
Size (WxHxD) mm:60x90x49.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, the output points are less than 14.
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simplee manipulator FX2NC-32EYT-DSS PDF catalog.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0.
FX1S provides up to 30 I/O points, and caan be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment FX2NC-32EYT-DSS PDF catalog.