For direct drive servo motor drive MR-J3-11KB-RJ080W datasheet PDF datasheet MITSUBISHI MR-J3-11KB-RJ080W PDF catalog

Drive unit 200VAC/400VAC level.
MITSUBISHI motor general AC servo amplifier MELSERVO-J3 series.
Need conversion unit MR-J3-CR55K) supporting the use of.
Rated output: 45kw.
Interface type: general pulse interface type.
Power specification: three phase AC400V.
Pulse train and analog input as universal interface MR-J3-11KB-RJ080W PDF datasheet .
Can choose the position, speed and torque control mode MR-J3-11KB-RJ080W
The use of advanced tuning features such as advanced vibration suppression control and adaptive filter,
Greatly improve the performance of the machine.
MR-J3, your partner.
Higher performance, more features, more convenient to use.
Highest performance in the industry.
Speed response frequency up to 2.1kHz. MITSUBISHI general purpose AC servo amplifier MR-J2 series MR-J3-11KB-RJ080W PDF datasheet .
Rated output: 0.1kw.
Interface: general purpose interface.
Voltage: single phase AC100V.
MITSUBISHI servo system in the MITSUBISHI servo amplifier is widely used,
It can not only be used in the high precision position control and speed control of the working machinery and general industrial machinery,
Can also be used in the field of speed control and tension control MR-J3-11KB-RJ080W PDF datasheet .
By installing a personal computer with a servo setting software, the parameters setting, trial run, state display, and gain adjustment are performed.
MITSUBISHI servo system MR-J2S column is developed on the basis of the servo MR-J2 series with a higher performance and more features of the MITSUBISHI servo system,
The control modes are position control, speed control and torque control, as well as the switching control mode among them MITSUBISHI MR-J3-11KB-RJ080W PDF catalog MITSUBISHI MR-J3-11KB-RJ080W PDF catalog. Drive: MR-H_ACN series built-in positioning function.
Rated output: 0.4KW.
In servo drive speed closed loop,
Rotor speed measurement accuracy is very important to improve the dynamic and static characteristics of the speed control loop MITSUBISHI MR-J3-11KB-RJ080W PDF catalog.
In order to seek the balance between measurement precision and system cost, incremental photoelectric encoder is generally used as the speed measuring sensor,
The corresponding method is M/T velocity measurement.
Although the M/T measurement method has a certain measurement accuracy and a wide range of measurement,
But this method has its inherent defects,
Mainly includes: the measurement period must be detected at least one complete encoder pulse, limiting the mminimum detectable speed MR-J3-11KB-RJ080W datasheet.
2 control system for speed control of the timer switch is difficult to maintain synchronization,
Can not guarantee the accuracy of measurement in the situation where the speed change is largger MR-J3-11KB-RJ080W PDF datasheet .
Therefore, it is difficult to improve the speed tracking and control performance of servo drive by using the traditional speed loop design method.