MITSUBISHI FR-F740P-75K-CHT PDF datasheet 3 phase 400V converter datasheet PDF catalog

Total input and output points: 48 points.
Input points: 24 points.
Output points: 24 points.
Output type: relay output.
Power supply voltage: AC100-240V.
Input signal voltage: DC24V.
8K capacity of the RAM memory, the maximum can be extended to 16K.
CPU arithmetic processing speed of 0.08 S/ basic instructions FR-F740P-75K-CHT PDF catalog.
On the right side of the FX2N series can be connected to the input and output expansion modules and special function modules FR-F740P-75K-CHT
The basic unit is built in the 2 axis independent maximum 20kHz positioning function (transistor output type).
Quick disconnect the terminal block, which adopts excellent maintainability to quickly disconnect the terminal blocks, even if the cable is then replaced by the cable FR-F740P-75K-CHT PDF catalog.
Clock function and hour meter function, all of the PLC FX2N has a real-time clock standard.
Continuous scanning function, to define the operation cycle for the application of the continuous scan time.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017).
Note recording function, Component annotation can be recorded in the program register FR-F740P-75K-CHT PDF catalog.
Online program editor, online change the program will not lose the working hours or stop production operation.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software can monitor, upload or uninstall programs and data via modem communications
Password protection, using a eight digit password to protect your program MITSUBISHI 3 phase 400V converter PDF catalog MITSUBISHI 3 phase 400V converter PDF catalog. Cable length: 0.5m.
RS-485 terminal unit conversion unit.
Applicable model: GT16. MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 3.7kw.
SLD converter rated current: 8.3A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed MITSUBISHI 3 phase 400V converter PDF catalog.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption.
Givee full play to the performance of the motor FR-F740P-75K-CHT PDF datasheet.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control FR-F740P-75K-CHT PDF catalog.