MITSUBISHI MR-J3-100B-RJ080W PDF datasheet MR-J3-100B-RJ080W datasheet PDF catalog

MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 45.0kw.
SSCNET interface.
Voltage: 3 phase AC400V.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0 MR-J3-100B-RJ080W PDF datasheet. 888ms.
Such systems will be able to provide high reliability and high performance MR-J3-100B-RJ080W
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system.
This simple connection method reduces the routing time and helps to prevent noise MR-J3-100B-RJ080W PDF datasheet.
Even in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit.
It is only necessary to add a battery on the servo amplifier, which can form the absolute value system.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use.The length of the line: 10M.
IP level: IP65 MR-J3-100B-RJ080W PDF datasheet.
Cable lead out direction: motor shaft different side.
Bending life: standard.
The cable is not shielded.
Encoder with cable (motor side); for HF-KP/HF-MP series (motor shaft with side extraction). Type: general purpose AC servo amplifier MR-E series.
Rated output: 1.0kw.
Interface type: general purpose pulse interface.
KH003 special mark for Super MR-E.
High performance and easy to operate, reduce work load.
Enhanced system cost performance.
High performance, high precision positioning (servo motor encoder resolution: 131072).
High response.
Suppression of vibration by adaptive vibration suppression control.
Using personal computer and servo setup software to optimize tuning.
Has 2 types of interfaces:
Position control and speed control with pulse train interface.
The analog input interface is used for speed control and torque control. Type: MR-J series.
Rated output: 0.4KW.
Applicable motor series: HA-FF, HA-SE.
Voltage: single phase AC100V.
It is very helpful to improve the stability of the low speed control of the servo motor.
But there is no direct effect to improve the accuracy of position control.
There are, of course, software compensation that is similar to pitch compensation,
Can improve the physical resolution of the single lap, so as to improve the accuracy of positioning control.
This can be effectively used in the use of the robot control of tthe indexing table MR-J3-100B-RJ080W PDF catalog.
It is also because of the application of splicing technology,
The rotary encoder will be more widely used in the high precision servo control in the harsh environment.
The use of rotary encoder with 224/ in the servo motor has been used in the servo motor MR-J3-100B-RJ080W PDF catalog.
Encoder serial communication system, the communication frequency can only be limited to 10M.