MR-J3-60T PDF datasheet MITSUBISHI MR-J3-60T datasheet PDF catalog

Cable length: 30m.
For MR-J2S-700A (4) /CP/CL or less.
Encoder for HC-SFS; HC-LFS; HC-RFS; 2000r/min HA-LFS; HC-UFS servo motor.
-L represents bending life.
"MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 1.0kw.
Built in positioning function.
Voltage: 3 phase AC200VAC or single phase AC230V MITSUBISHI MR-J3-60T PDF catalog.
Compatible with "MR-J2S- CP-S084" - servo amplifier and interface unit "MR-J2S-TO1" positioning by CC-Link
Simply setting the point table MR-J3-60T
AC servo can be used as the driving source of the field network.
Using servo amplifier built-in positioning function, position data and speed data, you can set the CC-Link.
Start, stop and display can also be transmitted through the CC-Link MITSUBISHI MR-J3-60T PDF catalog.
Serial communication reduces wiring.
AC servo distributed control system can be easily constructed. "Superior high efficiency IPM motor.
Output power: 37kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time MITSUBISHI MR-J3-60T PDF catalog. The length of the line: 10M.
IP level: IP65.
Bending life: standard.
Electric motor power supply cable for HF-KP/HF-MP series (motor shaft with side extraction). Drive: MR-H_ACN series SSC-NET compatible AC servo.
Rated output: 2.0KW.
The servo controller can easily transfer the operation module and the field bus module through the automation interface,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is single.
The servo controller is directly connected with a rotary transformer or an encoder, which forms a closed loop of speed and displacement control.
The general inverter can only form an open loop control system.
Servo controller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter. Fiber length: 40 meters.
SSCNET III cable (long distance optical fiber, high bending life).
Joints for CN1A and CN1B. 1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 11.0kw.
Interface: SSCNET III /H.
Power supply: three phase AC400V.
0.6kW and 1kW above the servo amplifier.
Servo amplifier supporting SSCNET III /H.
Complete synchronization system capable of using high speed serial optical communication.
Can be combined with the servo system controller to maximize the performance of the servo system.
Improve mechanical properties by high performance motor.
By improving the resolution and processing speed of the encoder,
The rotating servo motor has higherr precision and better performance of rotation MR-J3-60T PDF datasheet.
Only open a key type of adjustment function, can be carried out including mechanical resonance filter, high end seismic control II, low pass filter servo gain adjustment.
Easilyy start advanced seismic function, it can maximize the mechanical properties MR-J3-60T PDF datasheet.
It can automatically adjust the required response settings automatically.