Cable /G79-Y_C with loose wire connecting terminal.
L size: 5000mm.
Cable and loose wire cable with loose wire pressing connecting terminal,
Connector cable, MITSUBISHI motor produced PLC connection cable. Classification: Built-in operation indicator and diode model.
Plug-in terminals/Solder terminals G9SA-321-T15 PDF catalog.
Highly Reliable, 4-pole Miniature Relay Ideal,
for Sequence Control
G9SA-321-T15
Card lift-off employed for greater life and stable quality.
Long endurance and stable quality are assured by card lift-off system.
Mounting interchangeability with MY-series Relays.
Operation indicator mechanism incorporated for at-a-glance,
monitoring of ON/OFF operation. In addition, a built-in operation,
indicator model is also included in this Relay Series G9SA-321-T15 PDF catalog. Terminal (wire connection): Screw terminal.
Applicable output load: AC load.
Zero cross function: Yes.
Rated input voltage: AC 110V.
Global standard size,
low profile slim I/O relay with width 6.2 mm,
slim I/O solid state relay.
Realized about 25% lower profile than conventional,
products, contributing to further miniaturization of the,
control panel G9SA-321-T15 PDF catalog.
Push-In Plus terminal blocks are used to save wiring work,
in comparison with conventional screw terminals.
(Wiring time is reduced by 60%* in comparison with,
traditional screw terminals.).
No screw loosening means maintenance-free application,
realizing high reliability OMRON Safety Relay Unit PDF catalog.
Hand-free structure that holds an inserted flat-blade,
screwdriver to achieve easier wiring work for stranded wires OMRON Safety Relay Unit PDF catalog.
Screw terminal is also stocked to meet the screw type needs.
Mounted relay or solid-state relay has a plug-in terminal.
that is difficult to bend at the time of exchange. Category: power FET MOS relay output.
Points: 16 points (1a * 16).
Public connector side treatment: NPN (corresponding to the source of public) OMRON Safety Relay Unit PDF catalog.
Rated voltage: DC24V.
Pay attention to the use of convenience and space saving,
Relay terminal for 16 point output.
The terminal block is a long and thin type with a width of 135 * Deep 40mm.
It can be easily connected to the common end with the independent contact and short circuit chip.
Terminaal units for power supply wiring processing can be extended G9SA-321-T15 PDF datasheet.
M3.5 can be used with the Y fork type of the compression terminal (terminal width 6.2mm).
Can not use the tool to remove the relay. Relay replacement operation is simple G9SA-321-T15 PDF catalog.
Equipped with relay type and power FET MOS relay mounted type.
With action indication LED.
DIN guide rail installation, screw mounting common.