Analog I/O Units GRT1-OD8-1 REFERENCE MANUAL OMRON GRT1-OD8-1 Manual

Terminals: Push-In Plus terminal blocks.
Type: Output *2.
Points: 16.
Internal I/O circuit common: NPN (+ common).
Rated voltage: 24 VDC.
I/O Relay Terminals with 16 Points and,
Push-In Plus terminal blocks to,
Downsize Control Panels and Save Labor.
I/O Relay Terminals with 16 points to mount G2RV Slim I/O Relays GRT1-OD8-1 REFERENCE MANUAL.
Push-In Plus terminal blocks are used to save wiring work in,
comparison with traditional screw terminals GRT1-OD8-1 (Wiring time is,
reduced by 60%* in comparison with traditional screw terminals.).
Work is reduced ever further with one-step cable connection to the PLC.
Diode provided for coil surge absorption.
Operation indicators for immediate recognition of I/O signal status GRT1-OD8-1 REFERENCE MANUAL.
Accepts G3RV Slim I/O SSRs.
DIN Track or screw mounting. Number of phase: Single-phase.
Control terminal block: Terminal block with small slotted screws.
Type: Constant current.
Capacity: 20 A, 100 to 240 VAC.
Heater burnout detection: Yes.
Communications: Yes.
High-precision Control with Easy Setup,
Precise heater burnout detection.
Set value and present value monitoring with indicators GRT1-OD8-1 REFERENCE MANUAL.
Phase control or optimum cycle control.
RS-485 communications to set manipulated variables and,
monitor load current.
Total run time monitoring.
Output modes for phase control: proportional to phase angle,
proportional to voltage, proportional to square voltage,
and constant-current control OMRON GRT1-OD8-1 Manual.
Application with various loads: constant load resistance,
variable load resistance OMRON GRT1-OD8-1 Manual.
UL, and IEC/EN (TÜV) certified. Cable /G79-Y_C with loose wire connecting terminal.
L size: 1000mm.
Cable and loose wire cable with loose wire pressing connecting terminal,
Connector cable, MITSUBISHI motor produced PLC connection cable. Cable with connector (1 to 1) /G79-_C OMRON GRT1-OD8-1 Manual.
L size: 2000mm.
Cable and loose wire cable with loose wire pressing connecting terminal,
Connector cable, MITSUBISHI motor produced PLC connection cable. Classification: Output.
Innternal I/O circuit common: PNP (– common) GRT1-OD8-1 .
Rated voltage: 24 VDC.
Reduces Wiring while Providing I/O.
Flexibility.
Mount I/O relays and I/O SSRs freely.
Electric-shock preventive (finger-touch protection) terminal.
block incorporated conforming to VDE 0160 GRT1-OD8-1 REFERENCE MANUAL.
Connects to the PC and SBC easily via a connector.
DIN track mounted.
I/O Block conforming to VDE 0160.