CA8-ODP10-01 Manual Proface CA8-ODP10-01 User's Manual

The host controller is connected to the host computer interface, which is used for multiple connection (n:1) communication.For 5.7 inch models, prevent cable loose from the USB cable fastening clip (5 / set).13 pin input connectors for HTB and 16 pin output connectors. (1 / set)Expansion module for the GP3000 access to the CANopen network and communication with the CANopen master stationExpansion module for the GP3000 access to the PROFIBUS network and DP PROFIBUS master communicationCOM2 module is applicable for the isolation of COM2 through a variety of hosts and GP3000 connection2GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card Proface CA8-ODP10-01 User's Manual Proface CA8-ODP10-01 User's Manual CA8-ODP10-01 USB cable to prevent disconnection of the fastening clip (5 / set)10.4 inches (TFT), thin film for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).Connect to the SIEMENS PLC or MPI, used to connect the commercial type PROFIBUS connector COM25.7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set) Proface CA8-ODP10-01 User's Manual. Adapter for EX module (5 / set)For 3.8 inch models, connect the connector to the DIO interface. For connecting external I/O devices. (5 / set)Adapter for EX module (5 / set)15 inches, replaced by a host of backlight (1).Disposable film (5 sheets / sets) for protecting screen against contamination of human computer interfaceTransmission screen data, such as the USB cable, PC (Type-A USB) to the man-machine interface USB (Type-A)COM1 interface with the cable for direct connection to the CPU series PLC QAdapter for EX module (5 / set)The main controller is connected to the host computer interface (can be switched between RS-232C and RS-422) using the isolation module.Engineerinng documents created by the LT interface to download images and logic programming software through the USB interface CA8-ODP10-01 Manual. 7.5 inches /3.8 inches /5.7 inches, used to connect the power cord (5 / sets).COM2 terminal adapter for communiccation through the RS-422/485 connectionFor 5 CA8-ODP10-01 Manual. 7 inch models, for the 5.7 inch man-machine interface into the LT series (A/B/B+/C/H Type) of the opening.